Honeywell CN80L1N, CN80L0N User Manual
Dolphin™ CN80
powered by Android™ 7
Quick Start Guide
CN80-A7-EN-QS Rev (a)
2/18
Draft, Not for Release, 2/7/18
Out of the Box
Draft, Not for Release, 2/7/18
Make sure that your shipping box contains these items:
• Dolphin CN80 mobile computer (Model CN80L0N or
CN80L1N)
• Rechargeable 3.85 VDC Li-ion battery
• Product documentation
If you ordered accessories for your CN80, verify that they are
also included with the order. Be sure to keep the original
packaging in case you need to return the mobile computer for
service.
Note: CN80L0N models do not include a WWAN radio.
Memory Card Specifications
Honeywell recommends the use of Single Level Cell (SLC)
industrial grade microSD™ or microSDHC™ memory cards with
Dolphin mobile computers for maximum performance and
durability. Contact a Honeywell sales representative for
additional information on qualified memory card options.
2
Mobile Computer Features
Scan
Button
Microphone
Power
Button
Battery Status /Notification LED
Good Read LED
Receiver Speaker
Touch Panel
Scan Button
I/O Connector
Power
Button
Aux
Keyboard
(model dependent)
Speakers
Draft, Not for Release, 2/7/18
3
Note: Hand strap not shown.
Camera Lens and
Flash
Battery
Scan Button
Battery Latch
Imager (LED / Laser Aperture)
microSIM/
microSD Card
Door
Laser Safety
Label Location
Volume Buttons
microSIM/
microSD Card
Door
Door
Screws
Draft, Not for Release, 2/7/18
4
Install a microSD Card (SD)
Draft, Not for Release, 2/7/18
Note: Format the microSD card before initial use.
Always power off the computer before attempting to
install or remove a card.
1. Remove the two screws holding the card access door
closed.
2. Pull gently on the tab to open the door.
3. Press down gently on the center card holder.
4. Slide the holder toward the bottom of the unit, and then lift
up the edge.
5. Insert the microSD card into the card holder with the
contacts facing out.
6. Close the holder with the card inserted.
7. Press down gently on the holder and slide it into the locked
position.
8. Close the card access door.
9. Install the two screws to secure the door closed.
5
Loading...