Homelite LM-16001-69 User Manual

46''Angle Dozer No.LM-l600l-69

Assembly Instructions and Parts List

r

Mfr’s. No. 169)

forT-IO,T-l2,T-l5S T-16 Tractors

PART NO. 24745

Assembly

1. Attach the pivot frame assembly to the blade using two
1/2-13 X 1-1/2” capscrews, two spacers and twol/2-13”_
locknuts. (Figure 1.)

2. Connect the top of the pivot frame assembly to the blade

with the two eye bolts and two springs provided. Allow

1/2” of thread to show through the nuts. (Figure 2.)

5. Move the tractor lift mechanism to the down position.
Place the hooked end of the lift rod through the hole in
the tractor lift lever. Secure with a quick pin. Adjust
the set collars on the spring end so the dog on the rod
guide will fit in the hole in the lift arm on the push bar
assembly. Adjust the rear set collar so that it touches
the spring. This assembly will absorb most of the shock
should you strike an object while plowing and help pre
vent serious damage to the tractor.

6. Insert the pivot rod through its brackets and secure with
a cotter pin through each end.

Operation

There are five operating positions for this blade. The po
sitions can be changed by the operator without leaving his
seat. Turn the control rod counterclockwise to iinlatch the
blade. Push or pull the control rod to move the blade to the
desired position. For ease of changing positions, raise the
blade slightly from the ground.

The shoe assemblies are slotted to permit adjustment for

various types of gTound to be plowed. The blade should be
set high when plowing gravel drives and walks. Lower the
blade when plowing asphalt or concrete drives and walks.
Increased height adjustment can be made as follows:

3. Mount the push bar assembly to the rear hole of the
tractor front mounting plates using two hitch pins and

two quick pins. (Figure 3.)

4. The handle support bracket is mounted on the side panel

on the right side of the tractor with two 1/4-20 x 5/8”
capscrews (these replace the original screws) and two
1/4” lockwashers.

a) Manual Lift - by repositioning the stop pin in the lift

lever quadrant.

b) Electric Lift - by lowering the blade only as far as de

sired.

The snow deflector should be installed whenever the tractor
is to be used in cold weather. Remove the deflector for
warm weather operation. The deflector moirnts on the left
side of the tractor hood.

The wear plate on the blade is reversible. Should it become

worn, it may be removed, reversed and reinstalled.

Lubrication

Lubricate all joints where rods enter holes. Also lubricate
all pivot points. Periodic lubrication will assist in ease of
operation.

Recommended Equipment
Front Wheel Weights

Rear Wheel Weights
Tire Chains;

T-10
T-12, T-15

NOTE: Loose mounting

cleaning.

LM 09904 49
LM 09907 08

LM 09903 15
LM 09905 23

of chains will make them self-

'v.,