Hobart ML-104568 User Manual

I

N

S

T

R

U

C

T

I

O

N

S

A200 MIXERS

MODEL

A200 ML-104567
A200T ML-104568
A200DT ML-104569
A200FT ML-104570

701 S. RIDGE AVENUE

TROY, OHIO 45374-0001

FORM 19354 Rev. A (6-98)

MODEL A200 MIXER

– 2 –

Installation, Operation, and Care of

A200 MIXERS

SAVE THESE INSTRUCTIONS

GENERAL

The model A200 mixer is a 20 quart, bench-type mixer with a 1/2 H.P. motor, and a #12 attachment hub.
With the use of special agitators, a 12 quart bowl may be used on the A200 mixers.

The floor model A200FT and the deluxe finish model A200DT are equipped with a timer.
Most A200 mixers are equipped with a 0 - 15 minute timer.
There are a variety of attachments and accessories available for all models, and these are explained

in a separate

Use and Applications Handbook

which is supplied with each mixer.

INSTALLATION

UNPACKING

Immediately after unpacking the mixer, check for possible shipping damage. If this machine is found
to be damaged after unpacking, save the packaging material and contact the carrier within 15 days of
delivery.

Prior to installation, test the electrical service to assure that it agrees with the specifications on the
machine data plate.

LOCATION

Place the mixer on a suitable sturdy level surface. There should be adequate space around the mixer
for the user to operate the controls and install and remove bowls.

Holes are provided in the base to permanently secure the mixer, although this is not necessary in
normal installations. Four plastic plugs are supplied with the mixer to plug these holes if they are not
used.

ELECTRICAL CONNECTIONS (Cord Connected Mixers)
WARNING: THE ELECTRICAL CORD ON THIS MACHINE IS EQUIPPED WITH A THREE-PRONGED

GROUNDING PLUG WHICH MUST BE CONNECTED TO A PROPERLY GROUNDED RECEPTACLE.
IF THE RECEPTACLE IS NOT THE PROPER GROUNDING TYPE, CONTACT AN ELECTRICIAN.
DO NOT REMOVE THE GROUNDING PRONG FROM THE PLUG.

– 3 –