Item # _____________________________________
Quantity ___________________________________
C.S.I. Section 11400
VENTLESS
701 S Ridge Avenue, Troy, OH 45374
1-888-4HOBART • www.hobartcorp.com
STANDARD FEATURES
■ Internal condensing system minimizes water
vapor
■ Does not require a vent hood
■ Energy recovery
■ Sense-A-Temp™ 70°F rise electric booster heater
■ .74 gallons per rack nal rinse water
■ 40 racks per hour – hot water sanitizing
■ NSF pot and pan listed for 2-, 4- & 6- minute
cycles plus condense time
■ Timed wash cycles for 1, 2, 4 or 6 minutes plus
condense time
■ Solid state, integrated controls with digital status
indicators
■ Self-draining, high efciency stainless steel pump
and stainless steel impeller
■ Stainless steel drawn tank, tank shelf, chamber,
trim panels, frame and feet
■ Spring counterbalanced chamber with UHMW
polyethylene guides
■ Revolving, interchangeable upper and lower anticlogging wash arms
■ Revolving, interchangeable upper and lower rinse
arms
■ Slanted, self-locating, one-piece scrap screen
and basket system
■ Pumped rinse for constant rinse pressure
■ Cycle light
■ End of cycle audible alarm (eld activated)
■ Automatic ll
■ Door actuated start
■ Automatic drain closure
■ Delime cycle with notication (eld activated)
■ Service diagnostics
■ NAFEM Data Protocol capable
■ Straight-through or corner installation
■ Hot water sanitation
DOOR-TYPE DISHWASHER
MODEL
❑ AM15VL
OPTIONS AT EXTRA COST
❑ Single point electrical connection (3 phase only)
ACCESSORIES
❑ Peg rack
❑ Combination rack
❑ Splash shield for corner installations
❑ Flanged and seismic feet
❑ Drain water tempering kit
Specications, Details and Dimensions on Inside and Back.
VENTLESS DOOR-TYPE DISHWASHER
VOLTAGE
❑ 208-240/60/1
❑ 208-240/60/3
❑ 480/60/3
F-40271 – Ventless Door-Type Dishwasher Page 1 of 8
VENTLESS
DOOR-TYPE DISHWASHER
701 S Ridge Avenue, Troy, OH 45374
1-888-4HOBART • www.hobartcorp.com
Page 2 of 8 F-40271 – Ventless Door-Type Dishwasher
VENTLESS
701 S Ridge Avenue, Troy, OH 45374
1-888-4HOBART • www.hobartcorp.com
DOOR-TYPE DISHWASHER
F-40271 – Ventless Door-Type Dishwasher Page 3 of 8
VENTLESS
DOOR-TYPE DISHWASHER
701 S Ridge Avenue, Troy, OH 45374
1-888-4HOBART • www.hobartcorp.com
RECOMMENDED CONDENSE TIMES (BASED ON INCOMING WATER TEMP.)
INCOMING
TEMP. (F°)
60 30 10 40
65 33 11 37
70 36 12 36
75 39 13 34
80 42 14 33
85-90 45 15 32
CONDENSE TIME
(SEC.)
RINSE TIME (SEC.)
RACKS PER HOUR
(1 MIN. CYCLE)
Page 4 of 8 F-40271 – Ventless Door-Type Dishwasher
VENTLESS
701 S Ridge Avenue, Troy, OH 45374
1-888-4HOBART • www.hobartcorp.com
DOOR-TYPE DISHWASHER
F-40271 – Ventless Door-Type Dishwasher Page 5 of 8
VENTLESS
DOOR-TYPE DISHWASHER
701 S Ridge Avenue, Troy, OH 45374
1-888-4HOBART • www.hobartcorp.com
Ventless
Door-Type Dishwasher
Machine Ratings (Mechanical)
Racks per Hour (Max.)
Dishes per Hour (Average 25 per rack) 1,000
Glasses per Hour (Average 45 per rack) 1,8 0 0
Table to Table - Inside Tank at Table Connection (Inches) 251⁄4"
Overall Dimensions - (H x W x D) (Inches) 69" x 291⁄4" x 35"
Wash Motor H.P. 2
Wash Tank Capacity - Gallons 14
Wash Pump Capacity - Gallons per Minute - Weir Test 160
Electric Booster Heater (Kw)
Electric Heating Unit (Regulated) 5 Kw
Blower Motor H.P.
Rinse Pump Motor H.P.
Rinse - Minutes operated during hour of capacity operation 6.67
Seconds of rinse per rack 10
Rate of Rinse Flow - Gallons per Minute - at 20 lbs. Flow Pressure 4.4
Rinse Consumption - Gallons per Hour - Maximum - at 20 lbs. Flow Pressure 29.6
Rinse Cycle - Gallons per Rack - at 20 PSI Flow .74 - 180°F Min.
Peak Rate of Drain Flow - Gallons per Minute (Initial rate with full tank) 14
Exhaust Requirements 0
Shipping Weight Crated - Approx. lbs. - Unit only 451
40
8.5 Kw
1
/20
1
/15
Page 6 of 8 F-40271 – Ventless Door-Type Dishwasher
VENTLESS
701 S Ridge Avenue, Troy, OH 45374
1-888-4HOBART • www.hobartcorp.com
The microcomputer-based control system is built into
the Ventless Door-Type Dishwasher. It is
available in standard electrical specications of 208240/60/1, 208-240/60/3, 480/60/3 and is equipped
with a reduced voltage pilot circuit transformer.
Water hardness must be controlled to 3 grains of
hardness or less for best results.
CONSTRUCTION: Drawn tank, tank shelf and feet
constructed of 16 gauge stainless steel. Wash chamber and front trim panel above motor compartment
are polished, satin nish. Frame is 12 gauge stainless
steel, chamber is 18 gauge, and removable trim panels are 20 gauge.
CHAMBER LIFT: Chamber coupled by stainless steel
handle, spring counterbalanced. Chamber guided for
ease of operation and long life.
WASH PUMP: With stainless steel pump and impeller,
integral with motor assures alignment and quiet operation. Pump shaft seal with stainless steel parts and
a carbon ceramic sealing interface. Easily removable
impeller housing permits ease of inspection. Capacity
160 GPM. Pump is completely self-draining.
WASH PUMP MOTOR: Built for Hobart, 2 H.P., with
inherent thermal protection, grease-packed ball bearings, splash-proof design, ventilated. Single-phase
is capacitor-start, induction-run type. Three-phase is
squirrel-cage, induction type.
RINSE PUMP: Powered by a 1⁄15 H.P. single phase
motor, the rinse pump is made of high strength engineered composite material.
BLOWER: The condenser blower is an all stainless
steel forward curved centrifugal wheel powered by
a 1⁄20 H.P. TEFC single phase motor for nearly silent
operation.
CONDENSER COIL: The condensing system using a
tube and n coil constructed of copper and corrosion
resistant aluminum.
MICROCOMPUTER CONTROL SYSTEM: Hobart
microcomputer controls, assembled within waterresistant enclosure, provide built-in performance and
reliability.
The microcomputer control, relays and contactors
are housed behind a stainless steel enclosure, hinged
to provide easy access for servicing. The line voltage electrical components are completely wired
with 105°C, 600V thermoplastic insulated wire with
stranded conductors. Electrical components are
DOOR-TYPE DISHWASHER
wired with type ST cord. Line disconnect switch NOT
furnished.
CYCLE OPERATION: The microcomputer-timing
program is started by closing the doors, which actuates the door cycle switch. The cycle light turns ON.
The microcomputer energizes the wash pump motor
contactor during the wash portion of the program.
After the wash, a dwell permits the upper wash manifold to drain. At the end of the dwell, the nal rinse
pump is energized. After the nal rinse pump turns off,
Sani-Dwell permits sanitization to continue. The Rinse
display remains on during this period. The Blower and
Cold Water Valve turn on for 30 seconds to condense
the vapor laden air inside of the chamber. The display
shows a count down time (in seconds) during this
operation. After the 30 seconds is complete the
Cycle Light turns OFF, completing the program. If the
microcomputer is interrupted during a cycle by the
door-cycle switch, the microcomputer is reset to the
beginning of the program. 40 racks per hour – 87 seconds: 38 Second Wash, 2 Second Dwell, 10 Second
Rinse, 7 Second Sani-Dwell. 30 Second Condensing.
Other programs can be pre-selected by your Hobart
service technician.
Manual wash cycle selector also provides selection of
2-, 4- or 6-minute wash cycles plus condense time for
heavier washing applications.
WASH: Hobart revolving stainless steel wash arms
with unrestricted openings above and below provide
thorough distribution of water jets to all dishware
surfaces. Arms are easily removable for cleaning and
are interchangeable. Stainless steel tubing manifold
connects upper and lower spray system.
RINSE: Rotating rinse arms, both upper and lower,
feature 14 rinse nozzles. The stainless steel upper and
lower rinse arms are easily removable without tools for
inspection and are interchangeable. The motor driven
rinse pump gives constant rinse pressure regardless
of water service supply pressure. Easy open brass line
strainer furnished.
HOT FILL: Microcomputer controlled ll is supplied
from the hot water service connection. It enters the
machine through an air gap system which protects
the potable water supply from contamination. Ratio
ll method is used giving the correct ll at any owing
water pressure.
COLD WATER : Cold water supplied to condenser coil
is heated during the condensing period at the end of
each cycle. This pre-heated water is supplied to the
booster for subsequent heating.
F-40271 – Ventless Door-Type Dishwasher Page 7 of 8
VENTLESS
DOOR-TYPE DISHWASHER
DRAIN AND OVERFLOW: Large bell type automatic
overow and drain valve controlled from inside of
machine. Drain automatically closed by lowering
chamber. Drain seal is large diameter, high temperature “O” ring. Cover for overow is integral part of the
standpipe.
STRAINER SYSTEM: Equipped with large, exclusive
self-ushing, easily removable perforated stainless
steel, one-piece strainer and large capacity scrap
basket. Submerged scrap basket minimizes frequent
removal and cleaning.
HEATING EQUIPMENT: Standard tank heat is 5 KW
electric immersion heating element. Water temperature regulation is controlled by thermistor sensor in
combination with microcomputer controls. The tank
heat and positive low water protection microcomputer
circuits are automatically activated when the main
power switch is turned “on”. If tank is accidentally
701 S Ridge Avenue, Troy, OH 45374
1-888-4HOBART • www.hobartcorp.com
drained, low water protection device automatically
turns heat off. These features are standard with the
Hobart Microcomputer Control System.
ENERGY RECOVERY: Heat energy is recovered from
the condensation of vapors in the chamber at the end
of each cycle. This pre-heats the water for the next
rinse cycle from 55°F up to 140°F.
ELECTRIC BOOSTER HEATER: 8.5 KW electric
booster with Sense-A-TempTM technology adequately
sized to raise 110°F inlet water to 180°F.
ACCESSORIES: 193⁄4" x 193⁄4" peg and combination
dish racks. Splash shield for corner installations. End
of cycle audible alarm (eld activated). Delime notication (eld activated). Desirable functional accessories
can be furnished at added cost. See listed options
and accessories on this specication sheet. Write to
the factory for special requirements not listed above.
As continued product improvement is a policy of Hobart, specications are subject to change without notice.
Page 8 of 8 F-40271 – Ventless Door-Type Dishwasher
F-40271 (REV. 05/11) LITHO IN U.S.A. (H-01)
Loading...