Page 1
Software upgrade
harman/kardon
BDP 1 / BDP 10 Service Manual
Preparation to upgrade software
1) Start the CD Burning software and create a new CD
project (Data Disc)
2) Burn the oppointed data onto a blank CDR
A. Procedure for software upgrade:
1) Power on the set and insert the prepared Upgrade
CDR.
2) The set will starts reading disc & response with the
following display TV screen:
Upgrade File DETECTED
Upgrade?
Press Play TO START.
3) Press <OK> button to confirm, then screen will display :
Files coping…
UPGRADING…
4) The upgraded tray will automatically open when files
coping complete, then take out the disc.
5) About 1 minute later, the trace will automatically close
when upgrading complete.
*
B. Read out the software versions to confirm upgrading
1) Power on the set and press <Setup> button on the
remote control.
2) Then press down cursor on the remote control to choose
"System" , and press the right cursor on the remote control
to choose "software version".
The software version and other information are displayed
on the TV screen as follows:
Version information
CFE Version:X.XX.XX
APP Version:BDP_XX_VX.XX
LOADER Version:XXXX
FP MCU Version:HarmanXX_XXX
* The other upgrade SW way is by memory, the steps are the
same as CDR's, create the upgrade file into memory, and
connect the USB flash drive to the USB socket on set, then
press "USB" on remote control to access the content and
play the upgrade file as above upgrade procedure.
6) Restart the set after above steps;
Remark: If the upgraded software
shows an error message:
A. Same version: Upgrade software twice.
B. Different version: Upgrade the software versions one after
the other, and make sure to upgrade the current version first.
Caution: The set
MUST NOT be powered off
during upgrading, otherwise the Main Board
will be irreparably damaged.
Loading...