Groen PS-S User Manual

WATER TREATMENT SYSTEM

PROJECT NAME:

LOCATION:

ITEM NO:

REPLACEABLE CARTRIDGE MODEL PS-S

The Water Treatment system shall be a Groen PureSteem model# 153119, designed specifically for use with
the Groen Model: _______________ (insert Combo or steamer model number).

CONSTRUCTION: System shall consist of a

mounting bracket with a single cartridge head and
integrated manifold and water shutoff valve. Manifold
head shall be designed for quick and easy cartridge
replacement.

REPLACEABLE TREATMENT
CARTRIDGES: System shall employ a single

replaceable cartridge that locks into the matching
manifold head. The Cartridge is a modified-molded block
carbon type filter designed to remove silt, sediment and
other suspended particles down to 0.5 micron (nominal)
in size; and to reduce corrosive chlorine from inlet water
for a capacity of 22,000 gallons. The Cartridge shall
utilize IsoNet® (patented) scale and corrosion inhibitor
technology to inhibit the formation and accumulation of
scale (lime-scale) and to help protect against corrosion.

CARTRIDGE REPLACEMENT INTERVAL:

The Cartridge should be replaced every six months,
when capacity is reached or when effluent pressure or
flow becomes inadequate. Cartridges must be replaced
on a routine basis. The cartridge label includes a space
for writing in the cartridge installation date, the initials of
the service technician, and the “next replacement due”
date. Long-term protection against costly water-related
problems depends upon replacing the filter cartridge on
a timely basis.

INSTALLATION: Install by connecting a suitable

water line to the 3/8” FPT inlet of the full-flow ball
valve on the inlet of the Treatment System. NOTE:
All current production Combo, HyPerSteam and
HyPlus models are shipped with dual incoming water
connection fittings. One connection is for incoming
treated steam generator/boiler makeup water. The
other is for untreated condensate cooling water.
Connect treated water from the PureSteem System
to the treated steam generator/boiler makeup water
connection only. Provide untreated municipal water to
the condensate cooling water connection.
Mounting bracket to be secured to wall, post or
bracket with two metal screws and wall anchors
as needed to support 20 pounds. The unit must be
vertically mounted to a wall. Allow a minimum of 3”
under the housing to allow for filter cartridge removal
and replacement.

INSTALLATION LOCATION
RECOMMENDATION: It is recommended that

the PureSteem System be installed near the unit
(combo/steamer etc.) to facilitate simple routine filter
cartridge replacement. The system should not be
installed in a location where there is excessive heat
or where it could be damaged by moving equipment.

ORIGIN OF MANUFACTURE: Designed and

manufactured in the United States.

QTY:

MODEL NO:

AIA NO:

SIS NO:

Multi-stage, replaceable cartridge, in­line water treatment system. (Model
PS-S and cartridge shown)

OPTIONS/ACCESSORIES:

Replacement Cartridge [Part

No. 153120]

Water Treatment System

143382 RevD

Revised 04/12

PS-S

1055 Mendell Davis Drive, Jackson, MS 39272, 888-994-7636, unifiedbrands.net

© 2013 Unified Brands. All Rights Reserved. Unified Brands is a wholly-owned subsidiary of Dover Corporation.