Gold's Gym WGGRKOS060 Owner's Manual
USER’S MANUAL
Thank you for purchasing the
sturdy and durable Weight Plate
Storage Rack. The Weight Plate
Storage Rack will speed up your
workouts, provide convenient
access to your weights, and keep
your workout area organized.
For your safety and benefit,
please read this manual before
using the Weight Plate Storage
If you have questions after
Rack.
reading this manual, or if you need
to order replacement parts, please
call Customer Service toll-free at
1-800-288-4802, Mon.–Fri.,
6 a.m.–6 p.m. Mountain Time
(excluding holidays).
Weight Plate Storage Rack
Model WGGRKOS06
IMPORTANT PRECAUTIONS
WARNING: To reduce the risk of serious injury, read the following precautions before using
the weight plate storage rack.
1. Inspect and tighten all parts often. Replace any
worn parts immediately.
2. The rack is intended for home use only. Do not
use the rack in a commercial, rental, or institutional setting.
3. Use the rack only on a level surface. Place a mat
on the floor beneath the rack to protect the floor.
4. Keep children under the age of 12 and pets away
from the rack at all times.
5. The rack is designed to support a maximum of
210 pounds of weights (not included).
6. The warning decal shown at
the right has been placed on
the rack in the location
shown in assembly step 2
(see page 2). If the decal is
missing or illegible, call the
toll-free telephone number
listed above to order a free
replacement decal. Apply the
decal in the location shown in
assembly step 2.
ASSEMBLY INSTRUCTIONS
. Press two 50mm Square Outer Caps (9) onto the ends
1
of a Support Tube (2). Attach the Support Tube to the
ase (1) with two M8 x 65mm Bolts (11), two
B
M8 Washers (12), and two M8 Nylon Locknuts (13).
ot tighten the Nylon Locknuts yet
n
Assemble the other Support Tube (2) in the same way.
.
Do
1
2
1
13
13
2
9
12
2. Insert four M8 x 65mm Carriage Bolts (10) into the
Support Tubes (2) from underneath as shown.
Identify the Left Upright (4), which has a warning decal
near the upper end. Slide the Left Upright onto the two
M8 x 65mm Carriage Bolts (10) in the indicated Support
Tube. Slide the Right Upright (3) onto the two Carriage
Bolts in the other Support Tube. Insert the Top Cap (5)
into both Uprights.
Thread four M8 Nylon Locknuts (13) onto the
M8 x 65mm Carriage Bolts (10);
Nylon Locknuts yet.
do not tighten the
2
Warning Decal
2
13
9
10
12
5
4
13
1
2
10
3
10
11
13
Attach the Curl Bar Holder (6) to the Uprights (3, 4) with
3.
three M8 x 65mm Bolts (1
and three M8 Nylon Locknuts (13).
See steps 1–2. T
used in the previous steps.
ighten all the M8 Nylon Locknuts (13)
1), three M8 W
ashers (12),
3
6
1
1
4
2
12
13
12
3
Loading...