GE Industrial Solutions SGDA, SGHA, SGLA, SGPA User Manual

quip

DEH045 Installation Instructions R05

Spectra Series™ Power Panelboards

Circuit Breaker Cover

WARNING: Danger of electrical shock or injury.

OFF

Turn switchboard before workin

ment or removing any component. Do

e not remove circuit other component until the power is turned OFF.

ower ahead of the panelboard or

inside the

rotective devices or an

General

These instructions apply to the following circuit breaker frames: SGDA, SGHA, SGLA, and SGPA.

Installation

1. Select the breaker cover supports and breaker covers.

Table 1 lists the catalog numbers of the appropriate breaker covers for various switchboard and panelboard sizes.

Switchboard or Panelboard Width

Cover Height

SGDA, SGHA, SGLA, and SGPA – Single-branch mount

51/2" (4X) 208C4262G16 208C4262G17 208C4262G18

SGDA, SGHA, SGLA, and SGPA – Double-branch mount

51/2" (4X) N/A 208C4262G49* 208C4262G19

* For 40"-wide panelboards or switchboards only.

Figure 1. Circuit breaker cover catalog numbers for various

2. Install the circuit breaker according to the breaker mounting instructions.

3. Install the space filler. A space filler is only required with a single breaker installed in a double-branch configuration. Secure the steel space filler with two #10-32 x Figures 1 and 2.

4. Install the cover plate and center barrier.

• Single-branch applications. Attach the plastic

• Double-branch applications. Assemble two #10-16

27 & 31" Pnlbd

35" Swbd

panelboard and switchboard widths.

/8" screws, tightened to 25 in-lb, as shown in

spacer bars, as shown in 3, with four #6-20 x 1" washer-head screws and four #6 nut clips. Attach the cover plate assembly to the circuit breaker. Tighten the screws to 10 in-lb.

/2" washer-head screws and two #10 nut clips in

x the cover, as shown in Figure 1 for a single breaker and Figure 4 for two breakers. Attach the cover plate assembly to the circuit breaker center barrier and tighten the screws to 10 in-lb.

36 & 40" Pnlbd

40" Swbd

44" Pnlbd 45" Swbd

Space Filler

#10 Nut

Clips

#10-16

Screws

#10-32

Screws

Figure 1. Attaching the space filler to the breaker cover and the

assembled cover to the breaker.

Figure 2. Completed assembly with a space filler.

#6-20

Screws

Plastic

Spacer

Figure 3. Attaching the plastic spacer bars in a single-branch

application.

#6 Nut

Clips

quip

#10 Nut

Clips

#10-16

Screws

Figure 4. Attaching the assembled cover in a double-breaker

application.

These instructions do not cover all details or variations in e ma

be met in connection with installation, operation, or maintenance. Should further information be desired or should

articular problems arise that are not covered sufficiently for the purchaser’s purposes, the matter should be referred to the

GE Company.

ment nor do they provide for every possible contingency that

GE Industrial Systems

General Electric Company 41 Woodford Ave., Plainville, CT 06062