Gaylord ELX-UV-BBC-CL User Manual

MODEL “ELX-UV-BBC-CL”

HIGH EFFICIENCY EXTRACTOR VENTILATOR

GENERAL SPECIFICATIONS

Furnish Gaylord Ventilator Model “ELX-UV-BBC-CL-___________” as shown
on plans and in accordance with the following specications:

DESCRIPTION: The ventilator shall include a “V” bank arrangement of
“XGS” Super High Eciency Filtration Extractors and a stationary grease
collecting gutter at the bottom of the “V” bank, sloped to a drain at one end
to a removable stainless steel 0.5 gallon grease cup. The sloped gutter shall
be concealed by an apron which extends the full length of the hood. Each
ventilator shall contain two or more “XGS” Super High Eciency Filtration
Extractors. “XGS” Extractors shall utilize the “capture and drain” principle.

The ventilator shall achieve its low air ow rates without the use of
internal motors, plenums, or jets. The ventilator shall also include a “Super
Capture”TM lip on the front panel for enhancement of smoke and grease
capture. The ventilator shall include an “Autostart” controller and sensors
to meet current IMC standards.

The ventilator shall include a static pressure port in each section to be
used in balancing the static pressure. Continuous front and rear mounting
brackets shall be provided to facilitate hanging from the overhead building
structure.

The ventilator shall include ultraviolet lamps mounted in modules located
in the plenum section. There shall be one or more UV modules, as dictated
by the ventilator length, and each module shall be on a slide track for easy
removal. Access to the UV modules shall be through tooled removable
UV module doors. A pressure switch shall be provided to monitor the
airow and prevent operation of the UV lamps if the tooled removable
UV module doors is opened, or if any “XGS” Extractor is removed, or if
the airow is inadequate. Mounted on the face of the plenum of each
ventilator section shall be indicating lights to monitor “UV System On”,
“UV Lamp Failure” and “UV Safety Interlock Activated”.

o Gaylord Balancing Damper (GBD - Standard Equipment)
The ventilator shall be equipped with an opposed blade balancing damper.
The damper shall be manually adjustable and accessible from below.

o Gaylo rd Elec tric B ala ncing Dam per (G EBD - O pti onal)
The ventilator shall be equipped with an opposed blade balancing
damper that is controlled by an electrically driven actuator located at
each duct collar.

o Fuse Link Damper (FDD - Optional)
The ventilator shall be equipped with a fuse link activated re damper
located at the duct collar.

o No Damper (ND - Optional)

ELX

SERIES

ITEM NO. _______________

APPLICATION

Used for cafeteria lines or single island arrangements for use over all types
of equipment; ovens, broilers, griddles, fryers, ranges, steam equipment, etc.

CONSTRUCTION: The ventilator shall be of all stainless steel construction,
not less than 18 gauge, type 300 series. All exposed surfaces shall be a
number 4 nish. The use of aluminized steel, galvanized steel, or 430
stainless steel is not acceptable.

LIGHT FIXTURES: The ventilator shall be equipped with:

o Recessed LED

o Recessed uorescent
o 100 watt surface mounted incandescent
o 150 watt recessed incandescent

Light xtures shall be factory pre-wired to a single connection point.
Ventilators built in multiple sections shall be furnished with coiled ex
conduit for interconnecting sections.

ACCEPTANCE & APPROVALS: The ventilator shall be listed to UL
standard 710 and be ETL Sanitation listed. The ventilator shall comply
with all requirements of NFPA-96, IMC, UMC, BOCA and SBCCI mechanical
codes. The ventilator shall be capture tested to ASTM 1704-09. The “XGS”
Extractors shall be tested to ASTM 2519.

ENERGLINK DESIGN FEATURES

• Internal Canopy Radius

• Enhanced “XGS” Extractor Angle and Slot Spacing

• Faceted “Super Capture”™ Lip

OPTIONAL EQUIPMENT

1. “XGS” Spark Arrestor Extractors

2. Decorative Facings and Trim

3. Exhaust Fans, Supply Fans, & Roof Top Units

4. Fire Extinguisher Systems

5. Pollution Control Systems

6. Demand Ventilation Controls

6 Watts / Ft. Min.

12 Watts / Ft. Min.

24 Watts / Ft. Min.

36 Watts / Ft. Min.

GAYLORD INDUSTRIES

10900 SW AVERY ST • TUALATIN, OREGON 97062 U.S.A.

PHONE: [phone] • FAX: [phone] • email: [e-mail]

www.gaylordusa.com

ELX

30” STANDARD
ALSO AVAILABLE
24” HIGH

*16’ -0” MAX. UNIT LENGTH.
FOR GREATER LENGTH, JOIN TWO OR MORE
SECTIONS TOGETHER. ALLOW 12” MIN.
OVERHANG AT EACH END.

54” MINIMUM.

DIMENSION VARIES

WITH DEPTH OF THE

EQUIPMENT.

SERIES

LIGHT FIXTURE

CONTINUOUS

HANGING BRACKET

SUPERCAPTURE™ LIP

6’-8”

MTG. HT.

12”

MIN.

10”

OR 12”

0.5 GALLON
GREASE CUP

“AUTOSTART” SENSOR

GAYLORD BALANCING DAMPER (LISTED)

“XGS” SUPER HIGH EFFICIENCY
FILTRATION EXTRAC TOR

12”

MIN.

ENGINEERING DATA

Mechanical Requirements

The amount of exhaust volume required is dependent upon the type of cooking
equipment and the type and volume of cooking. Contact factory for exhaust
volumes, duct sizes, and static pressures.

Electrical

o Provide a 120 volt 20 amp, o 220/240 volt, 50/60 Hz., Non-Interrupted

service to Gaylord CUV-1000 Control Cabinet, to be fused separately. Provide
a separate 220/240 volt, 50/60 Hz, 20 amp service for every 2 ventilator sec­tions to power UV lamps. Ventilator lights to be on separate circuit, 120 volt
15 amp standard, 220/240 volt optional.

The manu facturer res erves the r ight to modif y the materi als and spe cifications resulting

Form No. ELX-UV-BBC-CL 0310-20198 © Copyright 2010, Gaylord Industries Litho USA

from a co ntinuing progr am of product improvement o r the availab ility of new materials

Ventilator Lengths

Maximum unit length 16’-0”. For greater lengths, join two or more sections together.
Check to ensure that there is adequate access into building and kitchen area.

Note: Ventilators manufactured outside North America; maximum unit length

*

10’-0”.

Hanging Weight

Ventilator Width 54” 60” 66”

Wt. / Lineal Ft. Lbs. 125 130 135