Garmin SA01933LA-D Instruction Manual

400W Series

Instructions for Continued Airworthiness

Document Number 190-00356-65 Rev. D

Garmin International, Inc.

1200 E. 151st Street

Olathe, Kansas 66062 USA

Record of Revision

Rev. Date Description of Change

1 10-19-06 Initial Release
A 11-03-06 Revision for STC Issuance

B 07-30-09 Add the “-D” to STC number when reissued under ODA

C 02-28-13 Revise to support software version 5.02. Clarify inspections. Add

electrical bonding check.

D 11-20-14 Revise to support software version 5.20 with Flight Stream 210.

Table of Contents

1.

 INTRODUCTION................................................................................................................... 3

1.1 PURPOSE ............................................................................................................ 3

1.2 Scope .................................................................................................................... 3

1.3 Document Control ................................................................................................. 3

1.4 Airworthiness Limitations Section ......................................................................... 3

1.5 Permission to Use Certain Documents ................................................................. 3

1.6 Definitions ............................................................................................................. 4

2. INSTRUCTIONS FOR CONTINUED AIRWORTHINESS .................................................... 4

2.1 Introduction ........................................................................................................... 4

2.2 Description of Alteration........................................................................................ 5

2.3 Control, Operating Information ............................................................................. 5

2.4 Servicing Information ............................................................................................ 5

2.5 Periodic Maintenance Instructions ........................................................................ 5

2.6 Troubleshooting Information ................................................................................. 7

2.7 Removal and Replacement Information ............................................................... 8

2.8 Diagrams .............................................................................................................. 11

2.9 Special Inspection Requirements ......................................................................... 11

2.10 Application of Protective Treatments .................................................................... 11

2.11 Data Relative to Structural Fasteners ................................................................... 12

2.12 Special Tools ........................................................................................................ 12

2.13 Additional Instructions........................................................................................... 12

2.14 Overhaul Period .................................................................................................... 12

2.15 ICA Revision and Distribution ............................................................................... 12

2.16 Assistance ............................................................................................................ 12 

2.17 Implementation and Record Keeping ................................................................... 12

400W Series P/N 190-00356-65 Rev. D
Instructions for Continued Airworthiness Page 2 of 12

1.6 Definitions

The following terminology is used within this document:

1) AC: Advisory Circular

2) ACO: Aircraft Certification Office

3) AEG: Aircraft Evaluation Group

4) BIT: Built in Test

5) CFR: Code of Federal Regulations

6) DER: Designated Engineering Representative

7) FAA: Federal Aviation Administration

8) IAW: In Accordance With

9) ICA: Instructions for Continued Airworthiness

10) MFD: Multi-Function Display unit

11) ODA: Organization Designation Authorization

12) PED: Portable Electronic Device

13) PMI: Primary Manufacturing Inspector

14) POI: Primary Operations Inspector

15) STC: Supplemental Type Certificate

16) TC: Type Certification or Type Certificate

17) TSO: Technical Standard Order

2. INSTRUCTIONS FOR CONTINUED AIRWORTHINESS

2.1 Introduction

Content, Scope, Purpose and Arrangement: This document identifies the Instructions for

Continued Airworthiness for the modification of the
aircraft by installation of the Garmin Models 400W
Series GPS/WAAS Nav/Com.

Applicability: Applies to aircraft altered by installation of the

Garmin Model 400W Series GPS/WAAS Nav/Com.
Definition of Abbreviations: See Section 1.6
Precautions: None
Units of measurement: None
Referenced publications:

Retention: This document, or the information contained within,

190-00356-02 Rev. K 400W Series Installation

Manual or later revision

005-C0221-00 Rev. J 400W Series STC Master

Data List or later revision

will be included in the aircraft’s permanent records.

400W Series P/N 190-00356-65 Rev. D
Instructions for Continued Airworthiness Page 4 of 12