Furuno FA-30 User Manual

FA-30 VHF SPLITTER

2

re

MOUNTING PROCEDURE

The VHF splitter enables the AIS receiver and VHF transceiver to share a single VHF antenna.

Note: The FA-30 can not receive AIS signal when the VHF transceiver is transmitting.

Equipment Lists

VHF Splitter: Type OP05-106, Code No. 000-011-704

No. Name Type Code No. Qty Remarks

1 VHF Splitter Assembly OP05-106-1 001-024-100 1 Rear panel + pcb 05P0817

2 Installation Materials CP05-11301 001-024-110 1 Cable tie CV-70N, 1 pc.

Mounting procedure

1. Open the detachable cover.

1. Put fingers on both sides and
pull outwards and lift up to
take off.

View Side View

2. Unfasten four screws to separate the
chassis from the mounting plate.

3. Disconnect plugs on J7, J12 and the
ground wire from pcb 05P0807 .

. Unfasten

four
screws.

3. Disconnect.

Ground wi

www.furuno.co.jp

4. Turn over the chassis. Then, disconnect mini coaxial wire from J2 on pcb 05P0808A.

H

05P8080A

ole

4.Disconnect mini coaxial wire.

Bottom view

5. Unfasten four screws from the rear panel to come free.

5. Unfasten four screws.

Rear panel

6. Pull out the cable assembly from the rear panel. (The rear panel may be dicarded.)

6. Push strongly here and pull out the cable.

7. Pass the cable assembly to the new rear panel.

8. Connect the plugs and ground wires to original places.

9. Pass two wires (two-core power cable and mini coaxial cable) from pcb 05P0817 on the new
rear panel through the hole on the chassis.

Pass two-core power cable and then mini coaxial cable.

10.Fix the new rear panel to the chassis with original four screws.

2