FRS23F4DB2
Frigidaire FRS23F4DB2, FRS23F4DB4, FRS23F4DQ1, FRS23F4DQ2, FRS23F4DQ4 Installation Guide
...
TO BE REMOVED BYTHE CUSTOMER AFTER INSTALLATION IS COMPLETE. (VeaotroUadoparaUaversi6ndelespahok)
f
[] INSTALLATION CHECKOFF LIST
DOORS
[] Handles are secure and tight
[] Door seals completely to cabinet on aHsides
[] Doors are leveUacross the top
Leveling
[] Refrigerator is nevel,side to side and tilted 1/4" (6ram) front to back
[] ToegdHe is properUy attached to refrigerator
[] Cabinet is setting solid on aHcorners
[]
[]
Electrical Power
House power turned on
Ice Maker
[] House water supply connected to refrigerator
[] Water & power couplings connected at door
[] No water leaks present at all connections - recheck in 24 hours
[] Ice Maker is turned ON.
[] Ice & Water Dispenser operates correctly
[] Front filter must be flush with filter housing (some models)
Final Checks
[] Shipping material removed
[] Fresh Food and Freezer controls set
[] Crisper Humidity controls set
[] Registration Card sent in
HAND TRUCKING
, Load refrigerator from side of cabinet
only.
Do not run retaining straps over
handles.
Do not oveFtighten retaining straps.
Never use refrigerator handles to
move the refrigerator.
Remove tape from doors only after
unit is in place.
iNSTALLATiON CLEARANCES
Allow the following clearances for ease of installation,
proper air circulation, and plumbing and electrical
connections:
Sides & Top.......... 3/8"
" Back ....................... 1"
NOTE: If you are installing your refrigerator beside a wall,
leave 1/2" minimum between hinges and wall to allow for
the door to swing open.
f
Ensureicemakertoturned ON.ChecktoseethattheIce& Water
Dispenser is operating correctly. (See Automatic Ice & Water
LD!spenser Fea!ures!n Use & CareManua!:)
SHIPPING MATERIAL
1 PIECE OF FOAM
OR CARDBOARD
2 WiRE TiES
(AI wire baskets
wil have 2 wie
ties)
,_:,_,_,_:_ii_ii_i I i
1 PIECE OF TAPE
.........1 PIECE OF TAPE OR
2 BLUE SHtPPING CLIPS
t PIECE OF TAPE
SHELF SPACER WITH TOE GRILLE
t PIECE OF TAPE
3 PIECES OF TAPE
t PIECE OF TAPE
f
LEVEUNG AND ADJUSTING
All four corners of refrigerator must rest firmly on a solid
floor.Your refrigerator has adjustable rollers to help level it
and to adjust the doors.
Tools You Will Need:
Ad,os,abIe' k 3,8
Fixed
Wrench
WATER SUPPLY
Connect water supply =check forwater leaks. Turn icemaker OFF
if water supply is not connected immediately. Connecting to a
reverse osmosis system is not recommended.
f
CONTROLS
S_art wi_ _tiiaos at -Fac _orv £aliin o"
To level cabinet or change door height: ' ....
.Removetoegr,,e. o/@ t oooo°A's
2. Usea screwdriver, 3/8"wrench, or nutdriverto adjust the [ _ '_ __ _
rollers.Toraise cabinet or door,turn screw clockwise.To
lower cabinet or door, turn screw counterclockwise.
If you need to remove the doors to get your refrigerator in the house, please See
Door Removal Instructions in your Use & Care Manual.
See"Normal Operating Sights & Sounds" inthe Use & Care
Manua/so you understand the sounds you may hear once
your refrigerator is running.
4 PJease read entire Use & Care Manua/to become aware of
important safety instructions and to become familiar with your
new refrigerator.
Send in Registration card to register your refrigerator.
4 Congratulations! Youare ready to enjoy your new refrigerator.
JFYOU ARE DiSSATiSFiED WiTH THE iNSTALLATION OFYOUR REFRIGERATOR, PLEASE CALLTHE STORE YOU PURCHASED JT FROM. P/N:241570200
Loading...