Frigidaire FRA11EPT111, FRA11EPT110, FRA113PT110, FRA09EPT113, FRA09EPT112 Owner’s Manual

F GIDAIRE

= i_ ii

Normal

Accessories Included

www,frigi

This USE & CARE MANUAL provides specific operating instructions for your model. Use the room air conditioner only as
instructed in this USE & CARE MANUAL. These instructions are not meant to cover every possible condition and situation that

may occur. Common sense and caution must be practiced when installing, operating, and maintaining any appliance.

Power supply cord

with 3-prong grounding

plug and current

detection device

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any
other appliance. Read product labels for flammability and other warnings.

For Your Safety

Prevent Accidents

• Be sure the electrical service is adequate for the model you have chosen. This information

can be found on the serial plate, which is located on the side of the cabinet.

o If the air conditioner is to be installed in a window, you will probably want to clean both

sides of the glass first.

• Be sure the air conditioner has been securely and correctly installed according to the
installation instructions in this manual. Save this manual for possible future use in

removing or reinstalling this unit.

Electrical Information

The complete electrical rating of your new protable air conditioner is stated on the serial

ii ii

plate. Refer to the rating when checking the electrical requirements.

ii

Be sure the air conditioner is properly grounded. To minimize shock and fire hazards,

ii'

proper grounding is important. The power cord is equipped with a three-prong grounding
plug for protection against shock hazards.

ii,

Your air conditioner must be used in a properly grounded wall receptacle. If the wall
receptacle you intend to use is not adequately grounded or protected by a time delay fuse

ii

or circuit breaker, have a qualified electrician install the proper receptacle.

ii =

Do not run air conditioner without outside protective cover in place. This could result in
mechanical damage within the air conditioner.

DANGER.I Avoid Serious Injury or Death

This air conditioner contains no user-serviceable parts. Always call an authorized Electrolux servicer for repairs.
Do not insert or place fingers or objects into the air discharge area on top of the unit.

Do not start or stop the air conditioner by unplugging the power cord or turning off the power at the electrical box.
Do not cut or damage the power cord.
If the power cord is damaged, it should only be replaced by an authorized Electrolux servicer.

In the event of a malfunction (sparks, burning smell, etc.), immediately stop the operation, disconnect the power cord, and call an authorized
Electrolux servicer.

• Do not operate the air conditioner with wet hands.

• Do not pull on the power cord.
Do not drink any water that is drained from the air conditioner.

02009 Electrolux Home Products, Inc. All rights reserved.

CAUTION. I Avoid Injury or damage to the unit or other property

o

Provide occasional ventilation during use. Do not direct airflow at fireplaces or other heat related sources as this could cause flare ups or make
units run excessively.

o

Do not climb on or place objects on the unit.
Do not hang objects off the unit.

Do not place containers with liquids on the unit.
Turn off the air conditioner at the power source when it will not be used for an extended period of time.

Periodically check the condition of the unit's installation accessories for any damage.
Do not apply heavy pressure to the radiator fins of the unit.

Operate the unit with air filter in place.
Do not block or cover the intake grille, discharge area and outlet ports.

Ensure that any electrical/electronic equipment is one yard away from the unit.
Do not use or store flammable gases near the unit.

READ THIS SECTION BEFORE ATTEMPTING TO OPERATE AIR CONDITIONER.

Unit must be upright for one hour prior to operating.

Operation of Current
Device

Plug in &
press RESET

The power supply cord contains a current device that senses damage to the power cord. To test

your power supply cord do the following:

1. Plug in the Air Conditioner.

2. The power supply cord will have TWO buttons on the plug head. Press the TEST button. You will
notice a click as the RESETbutton pops out.

3. Press the RESETbutton, Again you will notice a click as the button engages,

4. The power supply cord is now supplying electricity to the unit,

• Do not use this device to turn the unit on or off.

Always make sure the RESET button is pushed in for correct operation.

• The power supply cord must be replaced if it fails to reset when either the TEST button is pushed,

or it cannot be reset. A new one can be obtained from the product manufacturer.
If power supply cord is damaged, it CANNOT be repaired. It MUST be replaced by one obtained

from the product manufacturer.

02009 Electrolux Home Products, Inc. All rights reserved.

Product Registration Record Your Model and Serial Numbers

Record in the space provided below the model and serial numbers. On all models, the
serial plate is located on the side of the cabinet.

Model No.

Serial No.

Register Your Product

The self-addressed PRODUCT REGISTRATION CARD should be filled in completely,

signed and returned to the Frigidaire Company.

Normal Sounds

Sound of l?ushing Air

At the front of the unit, you may

hear the sound of rushing air
being moved by the fan.

High pitched Chatter
Today's high efficiency

compressors may have a
high pitched chatter during

the cooling cycle.

Gurgle/Hiss

"Gurgling or hissing" noise may be

heard due to refrigerant passing

through evaporator during normal

operation.

Vibration

Unit may vibrate and make noise
because of uneven floor.

02009 Electrolux Home Products, Inc. All rights reserved.