FoodSaver V1095 User Manual
Features
For important safety information and helpful tips, please refer to the FoodSaver Reference Guide
included in your kit. Questions? Visit us at www.foodsaver.com or call 1-800-777-5452 (U.S.) or
1-877-804-5383 (Canada). Get tips on vacuum packaging and order FoodSaver accessories.
Roll Storage
Compartment
Vacuum Channel
Antibacterial
Drip Tray
Rubber Gasket
Sealing Strip
M
L
K
J
I
Features of Your FoodSaver Appliance
QuickStart
V1095/GameSaver Deluxe
Shown V1095; GameSaver Deluxe operates in the same manner.
Accessory Hose
Accessory Hose
Storage
Cancel Button
Instant Seal Button
Accessory Port
Indicator Light
Seal Control Switch
(3-Position)
Bag Cutter
H
G
F
E
D
C
B
A
QS.1095_v2 4/29/04 2:29 PM Page 1
Bags & Rolls
1. Place item(s) in bag, allowing at least 3 inches
of space between bag contents and top of bag.
2. Open appliance lid and place open end of bag
down into Vacuum Channel
(J).
3. Close lid.
4. Turn Seal Control Switch (G) to Vacuum and Seal
or to Vacuum and Extended Seal (for moist or
juicy foods such as raw meat).
5. To begin vacuum process, press down firmly on
lid with both hands until motor starts, wait 3-5
seconds, then release. Motor will continue to run.
6. When motor and Indicator Light turn off, open lid
and remove bag. Refrigerate or freeze if needed.
(See FoodSaver Reference Guide for food safety tips.)
Note: Let appliance cool down for 20 seconds
after each use.
1. Open appliance lid and place roll into Roll Storage
Compartment
(I).
2. Pull out enough bag material to hold item to be
vacuum packaged, plus 3 inches. Close lid.
3. To cut bag material, press down lightly on lid and
slide Bag Cutter
(H) from one end of sliding channel
to other end.
4. Open appliance lid and tuck roll back into Roll
Storage Compartment.
5. Place one end of bag material across Sealing Strip
(M), not over rubber gasket (L), and close lid.
6. Turn Seal Control Switch (G) to Vacuum and Seal.
7. Press down firmly on lid with both hands until
motor starts, wait 3-5 seconds, then release.
Motor will continue to run.
8. When motor and Indicator Light (F) turn off,
open lid and remove bag.
Now you are ready to vacuum package with your
new bag (see below).
Getting Started
Registering your appliance is quick and easy at www.foodsaver.com.
How to Make a Bag from a FoodSaver Roll
How to Vacuum Package with FoodSaver Bags
Pull Out Bag Material Place Bag on Sealing Strip Press and Release Lid
Place Bag in Vacuum Channel Set Seal Control Switch Press and Release Lid
QS.1095_v2 4/29/04 2:29 PM Page 2
Loading...