Fisher Paykel DD24DAX9N, DD24DAB9, DD24SAX9N Quick Guide

QUICK START GUIDE
DishDrawer
NZ AU US CA GB IE
Keep this document handy for easy reference.
For detailed information on the features of your dishwasher, see your ‘User guide’.
Before using your dishwasher, make sure you read the full ‘User guide’, with special attention to the ‘Safety and warnings’ section.
For contact information or if you require service, assistance or replacement parts, see the end of this document or your ‘Service & warranty’ booklet.
TM
dishwasher
YOUR MODEL
Double models
DD60DAW9 DD60DAX9 DD60DAHW9 DD60DAHB9 DD60DAHX9 DD24DAW9 DD24DAB9 DD24DAX9
Note: each drawer can run independently of the other drawer.
Single models
DD60SAX9 DD60SAHX9 DD24SAW9 DD24SAB9 DD24SAX9
OPERATING INSTRUCTIONS - STARTING A WASH
14
2
3
Rotating Spray arm
Discard scraps
Scrape large food particles off (e.g. bones, fruit stones) and remove any foreign objects (e.g. toothpicks, strings, paper).
Load dishes carefully
To help with wash performance, arrange dishes so they are evenly spaced and not nesting.
Check spray arm(s) are mounted correctly and can rotate fully around
Check the spray arm is mounted correctly by physically rotating it around with your hand.
Before a wash, ensure there are no items blocking the spray arm(s) from rotating.
Powdered Detergent
A
Rinse aid
D
5
6
Tablet or Gel Pouch
B
C
Add detergent
Fill the detergent dispenser (A) with powdered detergent and close the dispenser door.
IMPORTANT!
Do not place liquid detergent or tablets in the detergent dispenser.
If using a tablet or gel pouch, place it in the cutlery basket (B) or at the bottom of the drawer.
Check rinse aid
If the indicator on its plug (C) glows bright red, refill the rinse aid dispenser (D) with liquid rinse aid. Make sure you then refit the rinse aid plug back into its original position, by rotating the plug back
into an upright position.
Select wash
Power the dishwasher on then select wash program
Start wash or set Delay start
Ensure drawer is closed.
To start wash: Press
To set delay start: Press and hold
to enter delay start, then press and hold
again to increase the delay
start time.
.
.
CONTROLS AND DISPLAY
Single models
F
HI
A
Double models
E
F
G
H
I
E
B
Controls Description
Off/On
A
Press
to turn the dishdrawer
on or off.
Opening the drawer will automatically turn the dishwasher on.
B
Drawer selector (Double models only)
Press to scroll between drawers.
C
Wash program selector
Press to scroll through wash program options.
Start / Delay Start
D
Press to start the wash. To pause: Press again. The wash stage indicator and (Double models) will flash.
Wait for the 3 short and one long tone before opening the drawer. Forcing it open mid cycle may cause damage or injury.
If the drawer is not restarted within 7 minutes it will tone intermittently until it is restarted.
WASH PROGRAMS
Double models interface shown
Wash program indicators
These show which program is selected.
J
KKL
DC
J
DCA
D
To Delay start
1 Press and hold until appears
on the display, then release. You are now in Delay start mode.
2 Press
until the display shows the number of hours you want to delay the start of a wash by (1 to 12 hours).
Note: If you scroll past 12 hours the dishwasher will exit Delay start mode. To re-enter delay start follow step 1 above.
The wash will start once the delay time is over, provided the drawer is
closed.
DD24 models only
If the drawer is opened after delay start has been set (for example if you need to load more dishes), delay start will be paused after the drawer
L
is closed.
To restart delay start:
Close the drawer.
Single models: will flash.
Double models: and will flash.
Press to resume.
Cancel wash/Cancel Delay start
Press to cancel a wash that has already started or to cancel the Delay start setting.
If there is any water in the drawer, it will automatically drain before the dishwasher turns off.
E
Keylock
Keylock disables all the buttons – helpful when cleaning the dishwasher.
Single models
To activate: press and hold until you hear one tone. The keylock indicator will come on. To cancel: press and hold until you hear another tone and the keylock indicator stops flashing and goes out.
Double models
To activate: press and hold and
together until you hear one tone. The keylock indicator will come on.
To cancel: press and hold and
together until you hear another tone and the keylock indicator stops flashing and goes out.
PROGRAM DESCRIPTION
Heavy Heavily soiled pots, pans and dishes.
Normal
(default setting)
Dishes that are quite heavily soiled or food soils that have been left to dry overnight.
Normal Eco Normally soiled dishes for optimum water and energy
usage. The US/Canada Energy Guide is based on this cycle.
Fast Lightly soiled dishes.
Delicate Lightly soiled and heat sensitive crockery.
Rinse Prevents odours and soils from drying on dishes.
Childlock
E
Childlock disables all the buttons and locks the drawer closed, preventing
unauthorized use by children.
Single models
To activate: press and hold
until you hear a second tone. The keylock indicator will come on. To cancel: press and hold until you hear another tone and the keylock indicator stops flashing and goes out.
Double models
To activate: press and hold and
together until you hear a second tone. The keylock indicator will come on.
To cancel: press and hold and
together until you hear another tone and the keylock indicator stops flashing and goes out.
F
Wash program indicators
These show which program is selected.
Drawer indicator (Double models only)
G
White: drawer is running and selected. Dim: drawer is running but not selected. Flashing: drawer is paused
Display
H
Time remaining (minutes)
Fault code numbers (see ‘If there is a fault’ in User guide).
Wash stage indicators
I
(See ‘During and after the wash cycle’).
Keylock/Childlock indicator
J
If lit: keylock or childlock is activated.
Delayed start indicator
K
If lit: delayed start is set.
L
Salt indicator
(Water softener models only) If lit: salt reservoir is empty.
continued >
PREFERENCE OPTIONSDURING AND AFTER THE WASH
As the wash progresses, the display will count down the minutes remaining and show what stage the program is at. When the program has finished, the display will show 0 and the dishwasher will sound a tone. After 30 seconds the display will go out.
You may notice the following noises at the end of the wash. These are all part of normal operation:
Both drawers may be draining simultaneously.
The drying fan may continue to run after a wash program has finished for a set time or until the drawer is opened. The fan assists with drying and uses negligible amounts of energy.
For best drying results, we recommend unloading the dishes once they have cooled.
DOS AND DON’TS OF LOADING
Sharp or pointed items must be placed horizontally or with sharp edges/points facing down to avoid risk of injury.
Protruding items will stop the internal lid of the dishwasher from sealing properly, which could result in a service call.
You can change the setting of these options to suit your preferences or circumstances. We recommend selecting the most suitable settings before you start using your dishwasher.
OPTION RINSE AID
What does it do?
How to change the setting of an option
1 CHECK
Check that there is no wash underway, press
2 ENTER MENU & SCROLL TO OPTION
To enter the menu: Press and hold the and together for four seconds.
To scroll to the next option: press . To know which option you’re in, watch the letters in the display (see table below). When you have scrolled to the end of the sequence, the menu will start again with Rinse aid.
Regulates the amount of rinse aid dispensed. Reduce this setting if there is excess foam after a wash. Increase this setting if dishes are wet or streaky after a wash.
You are now in the Rinse aid option of the preference options menu. If you want to change the Rinse aid setting, go to step 3 now. If you want to change the setting of another option, you will need to scroll to that option first.
WATER SOFTENER
(SOME MODELS ONLY)
Refer to the ‘Water softener’ section of the ‘User guide’ for details.
OPEN DRAWER AUTO POWER-ON
Your dishwasher is factory-set to automatically power on for 30 seconds whenever you open the drawer. You can turn this setting off.
TURN TONES OFF
This turns all tones off except for fault alerts.
CLOSED DRAWER AUTOLOCK
When this setting is on, the drawer will automatically lock 30 seconds after it’s closed. It can then be unlocked by pressing Keylock or Childlock is also activated). Useful in boats or motor homes.
(unless
A neatly arranged load with evenly spaced dishes helps wash performance.
Ensure there is enough space between plates. Mix spoons, knives and forks within the cutlery basket to prevent them from nesting.
Overcrowding reduces wash performance.
If plates and cutlery are nesting, they are less likely to be cleaned well.
OPTION RINSE AID
Which option am I in?
Possible settings
Example setting is 1
RA
Off to Max (rA5) Off to Max (Hd5) On or Off On or Off On or Off
WATER SOFTENER
(SOME MODELS ONLY)
HD AP BP LD
setting is 1
OPEN DRAWER AUTO POWER-ON
On
TONES AT END OF WASH
On
CLOSED DRAWER AUTOLOCK
On
RA1 HD1 APo BPo LDo
setting is 4
3 CHANGE SETTING
Press to change the setting within an option. For example, to change the Rinse aid setting from 4 (factory default) to 2, you need to press 3 times.
4 SAVE SETTING & QUIT MENU
Press . This will save the new setting and quit the preference options menu.
RA4 HD4 AP- BP- LD-
FOR MORE INFORMATION
For detailed information on the features of your dishwasher
setting is 4
see your ‘User guide’
Off
Off
Off
Ensure that water reaches all items on the racks.
Dishware is blocking water from reaching items on the racks.
For warranty information
If you…
have any questions or comments
need a Fisher & Paykel authorized technician to service your product
need replacement parts or accessories
want to register your product
see your ‘Service and warranty’ booklet
see your ‘Service and warranty’ booklet or contact us via our website:
www.fisherpaykel.com
591149A 07.16
Loading...