Fire-Lite FC-LPS Installation Instruction

The optional FC-LPS Local Playback Speaker Module can be used to

monitor the recorded digital message without transmitting the

message over the system speakers. The FC-LPS is necessary to take

advantage of the Playback feature. The speaker module plugs into

P2 of the main circuit board and is temporarily installed for testing.

Voice Evacuation Control Panel

FC-LPS Local Playback

Speaker Module

Product Installation Drawing

Document 50617 Rev B 5/27/97 ECN 97-215

It is not necessary to remove power when installing the FC-LPS Local Playback Speaker Module.

Temporary Installation of the FC-LPS Local Playback Speaker Module:

1. Remove the main circuit board mounting screw located to the right of power terminal block TB3. Refer to the illustration

below.

2. Install the supplied metal standoff in the mounting hole just vacated in step 1, and screw standoff into place.

3. Position the FC-LPS mounting bracket hole over the standoff and secure with the screw removed in step 1.

4. Plug the FC-LPS Local Playback Speaker Module's polarized connector into connector P2 on the main circuit board. P2 is

located on the bottom right of the main circuit board near the Control/Indicator panel.

5. Once testing has been completed, remove the FC-LPS and standoff and reinstall the screw. The FC-LPS is not approved for a

permanent connection.

Install FC-LPS Speaker Module on metal standoff

FC-LPS

Remove the mounting screw from

left center of main circuit board

Main Circuit Board

Voice Evacuation Control Panel

Remove mounting screw from main circuit board and install metal standoff

1,2

Install one metal standoff by

screwing into place

Main Circuit Board

Plug Speaker Module Cable into connector P2

Install Speaker Module and

secure with screw

Main Circuit Board

Speaker

Module