Quick Reference
Printing Without a Computer
Here’s how to use the control panel:
Ink Low: black Make sure you have a new black ink cartridge.
Ink Low: color Make sure you have a new color ink cartridge.
Ink Empty: black Replace the black ink cartridge.
Ink Empty: color Replace the color ink cartridge.
Paper End Load (or reload) paper and press the maintenance button.
Paper Jam Press the maintenance button to eject the jammed paper.
(If you’re using roll paper, press and hold the roll paper button.)
If you still see the error, turn off the printer, open the printer cover, and
remove all paper, including any torn pieces. Then reload paper, turn the
printer on, and press the maintenance button to continue.
Roll Out Cut your picture(s) off the roll. Then press the roll paper button
to feed the paper back into the printer.
Install Cartridge One of the ink cartridges is missing or not installed correctly. Remove the
cartridge and reinstall it.
Service Required Turn the printer off, wait a few seconds, and turn it back on. If you still see
the error, contact EPSON as described in Printer Basics.
Card Error The memory card is damaged or the data is corrupted. Try reformatting
the card in your camera.
Fatal Error Turn the printer off, wait a few seconds, and turn it back on. If you still see
the error, contact EPSON as described in Printer Basics.
Error Codes
Copyright © 2002 by Epson America, Inc. 12/02
Printed on recycled paper.
CPD-14524R1
4042684-00
EPSON Borderless Premium Glossy Photo Paper
4" x 6" S041682
5" x 7" S041464
8" x 10" S041465
EPSON Roll Paper
4" Premium Glossy Photo Paper S041302
4" Premium Semigloss Photo Paper S041329
EPSON Photo Stickers
®
S041144
Recommended Papers
The easy-to-use preview monitor (C12C860005)
lets you confirm your layouts before you print.
You don’t need to print an index.
Optional Preview Monitor
Printed in XXX
Print a sheet with
small, numbered copies
of all photos
Menus
Print all the photos on
the memory card
Print one selected photo Print a group of
selected photos
Use and buttons to select menus.
Press to adjust brightness
Press and hold to use filters
Select a photo to print
Cancel control panel settings
or cancel printing
Start printing
Use and buttons to select settings.
Printing with Special Effects
1. In the Copies menu, press and hold the
Brightness button until Filter No. flashes
on screen.
2. Press the button to select from the special
effect filters shown below.
3. Press the Brightness button again to lock in
your selection.
Printing an Index
An index print includes small, numbered copies
of all the pictures on the memory card.
Printing Snapshots
1. Load plain paper.
2. Make sure these settings appear
on the control panel:
1. Insert your memory card into the
appropriate adapter.
2. Insert the adapter into the card slot. Push it in
firmly so the button pops out.
Place the paper
against the right side
of the feeder
Slide the edge
guide against
the paper
1. Load EPSON®Borderless 4" x 6" Premium
Glossy Photo Paper.
Insert short edge first
with the glossy side up
Slide the edge
guide against
the paper
2. In the Print Mode menu, select Set.
3. In the Paper Type menu, select Glossy.
4. In the Paper Size menu, select 4x6.
5. In the Page Layout menu, select for
borderless prints, or for white borders.
6. In the Select Photo menu, press to select
the number of the photo you want to print.
See the index print for photo numbers.
7. Press the round Select Photo button.
8. Repeat steps 6 and 7 for each photo
you want to print.
9. Press the Print button.
Printing Special Layouts
You can print 2, 3, 4, or 20
photos per page by selecting these settings
on the Page Layout menu.
You can also...
Print multiple copies of the same image
on one page.
Turn a normal landscape into a panoramic photo.
Take a portrait and print 8 different sizes
on one sheet of paper.
Turn your favorite picture into photo stickers.
See your Printer Basics book for instructions.
3. Press the Print button.
Your index is printed.
Use it to select photos
for reprinting and enlarging.
no filter
Inserting a Memory Card
1—black and white
2—sepia 3—high contrast
4—one level brighter 5—two levels brighter
6—one level darker 7—two levels darker
8—more vivid 9—sharper
Number of
photos on
the card
1. Press the round Brightness button.
2. Press the button once or twice to make
your pictures 1 or 2 steps lighter.
Press the button once or twice to make
them 1 or 2 steps darker (-1 or -2 is displayed).
3. Press the Brightness button again to lock in
your selection.
Adjusting Brightness