Epson SC-T3050, SC-T5050, SC-T7050 Setup guide [ja]

JA
EN	Assembly	8
TC

		JA
		EN	Initial Ink Charging	14
		TC
	JA
		JA
		EN	Loading Roll Paper	16
		TC
		JA
	EN	EN	Installing the Software	20
	Setup Guide	TC
		JA
		EN	Seeing the Online Guide	23
	TC	TC

JA

JA

SC-T7050

A

B

c

A

U 6

B

10

1

SC-T3050 2 SC-T7050 SC-T5050 4 U PDF

U 9

ようにしてから作業を行ってください。

2

JA

					B
		A
					1
					1

••A

••15

3

JA

	A
					B
	••			••
	•• 65cm			••
	•• D
	/			••
	••
	••
	••
	AC100V
					B
	••
	••
	••
	••
	AC100V
	B

4

EN Introductions

Illustrations

Unless otherwise noted, the illustrations in this manual show the SC-T7000 series.

Safety Instructions

Read these instructions in their entirety before assembling the product, and be sure to follow the safety instructions in the printer’s User’s Guide when using the product.

When using the printer

Do not block or cover the openings in the printer.

Do not insert objects through the slots. Take care not to spill liquid on the printer.

Use only the power cord that comes with the printer. Use of another cord may result in fire or electric shock.

Except as specifically explained in your documentation, do not attempt to service the printer yourself.

Unplug the printer and refer servicing to qualified service personnel under the following conditions: The power cord or plug is damaged; liquid has entered the printer; the printer has been dropped or the cabinet damaged; the printer does not operate normally or exhibits a distinct change in performance.

Do not put your hand inside the printer or touch the ink cartridges during printing.

When handling the ink cartridges

Keep ink cartridges out of the reach of children and do not drink their contents.Store ink cartridges in a cool, dark place.

If ink gets on your skin, wash it off with soap and water. If ink gets in your eyes, flush them immediately with water.

Do not use an ink cartridge beyond the date printed on the cartridge carton.Use up the ink cartridge within six months of installation for best results.

Do not dismantle the ink cartridges or try to refill them. This could damage the print head.

Do not touch the ink supply port or its surrounding area and the green IC chip on the side of the ink cartridge. Doing so may affect normal operation and printing.

Meaning of Symbols

!Caution Cautions must be followed to avoid bodily injury.

c	Important : Important must be followed to avoid damage to this product.
	Note : Notes contain useful or additional information on the operation of this
	product.

TC

SC-T7070

說明。

Epson

沖洗。

IC

!

c

5

JA EN Choosing a Place for the Printer TC

SC-T7000 Series / SC-T5000 Series

SC-T3000 Series

	W	D	H
SC-T7000 Series	1768mm	1413mm	1278mm
SC-T5000 Series	1565mm	1413mm	1278mm
SC-T3000 Series*	1210mm	999mm	763mm

( 51kg)24 24600mm

**Before placing the printer on a platform or desk, be sure that it can support the printer’s weight of approximately 51 kg. An optional Stand (24”) is available from Epson; when using the stand, leave a space of at least 600 mm in front of the printer.

51 kg24” Epson 600 mm

特定の印刷条件では、図の寸法以上のスペースが前後に必要です。 詳細は、『ユーザーズガイド』(PDF)

SC-T7050 SC-T5050

10 35 20 80

Instructions for Placing the Printer

The flat place that can leave adequate room as shown in the table for setting up the printer. In addition, more room is required for the front and rear of the printer when printing under specific conditions. For more details, see the User’s Guide.

Always use the printer installed on its stand with SC-T7000 series and SC-T5000 series. If you place the printer unit directly on the floor or a desk, it may affect normal operation or printing.

Use only an outlet that meets the power requirements of this printer.Operate the printer under the following conditions:

Temperature: 10 to 35°C (59 to 95°F) Humidity: 20 to 80% without condensation

Even the conditions above are met, you may not print properly if the environmental conditions are not proper for the paper. See the instructions of the paper for more detailed information. Keep the printer away from drying, direct sunlight, or heat sources to maintain the appropriate humidity.

SC-T7070 SC-T5070

10 35

20 80%

6

JA EN Unpacking TC

SC-T3050 24

** The parts enclosed in the dashed border are not supplied with the SC-T3000 series but are included with the optional Stand (24”).

SC-T3070 24”

B

!Caution: Before assembling the printer, clear the work area by putting away the removed packing materials and bundled items.

!

7

JA EN Assembly TC

SC-T3050 (24)

3

If you are not using the SC-T3000 series with an optional Stand (24”), proceed to “Initial Ink Charging”.

It is recommended to assemble the stand by a group of three.

SC-T3070 24”

“ ”

Stand

[[[[[

[[[[[

[[[[[

c Before using the printer, be sure the stand is fixed in place. When moving the printer, unlock the casters.

Printer Installation

8