Epson SAA-101100, SAA-101200, SAA-102100, SAA-102200, SAA-111100 Datasheet

DOCUMENT NUMBER NCD-5DC2-01

SAA-1 Series

Single-Mode

FC ADAPTOR

TECHNICAL SPECIFICATIONS

Seiko Instruments Inc.

Components Sales Dept.
8, Nakase 1-Chome
Mihama-ku, Chiba-shi, Chiba-ken
261 JAPAN
Telephone : [phone]

-1215

Facsimile : 043-211-8035

SAA-1 Series Single-Mode FC ADAPTOR
TECHNICAL SPECIFICATIONS

Document Number NCD-5DC2-01

NAE63D01 " SAA-1 Part " May 1986
NAE63D02 " SAA-1 Part " September 1986
SSA930305 March 1993
39055-2016-01 September 1993
NCD-5DC2-01 December 1995

Copyright 1986, 1993, 1995 by Seiko Instruments Inc.

All right reserved.

The information contained herein shall not reproduced or disclosed to any third party
without the express written consent of SII.
The Specifications contained herein are subject to change without notice.

SII is a trademark of Seiko Instruments Inc.

Please address any questions, comments, and suggestions to:

Seiko Instruments USA Inc.

Electronics Components Division
2990 West Lomita Boulevard
Torrance, CA 90505, U.S.A.
Phone: [phone]
Fax: [phone]

Seiko Instruments (H.K.) Ltd.

Sales Department
4th & 5th Floor, Wyler Center 2
200 Tai Lin Pai Road, Kwai Chung
N.T., Kowloon, Hong Kong
Phone: [phone]
Fax: [phone]

Seiko Instruments GmbH

OFC Division
Siemensstraße 9b
D-63263 Neu-Isenburg, Germany
Phone: [phone]
Fax: [phone]

Seiko Instruments Taiwan Inc.

Sales Department
5F-1, No.99, Sec. 2, Chung Shan
Rd.
Taipei 104, Taiwan, R.O.C.
Phone: [phone]
Fax: [phone]

Seiko Instruments Singapore pte. Ltd.

2, Marsiling Lane,
Woodlands New Town,
Singapore, 2573, Singapore
Phone: [phone]
Fax: [phone]

ii

TABLE OF CONTENTS

Section Page

1. PROVISION 1

1.1 Application Limit 1

2. PARTS NUMBER 1

3. GENERAL SPECIFICATIONS 2

3.1 Parts and Materials 2

3.2 Physical Dimensions 2

3.3 General Tolerances 2

3.4 Insertion Loss 3

4. PACKING 3

5. SHIPPING INSPECTION 3

Table

Table 1 Parts Number 1
Table 2 Parts and Materials 2
Table 3 General Tolerance 2
Table 4 Insertion Loss and the Measurement Conditions 3

Figure

Figure 1 Insertion Loss Measurement System 3
Figure 2 SAA-1 Adaptor 4
Figure 3 to 4 Part Dimensions 5

iii