Epson F6070 User Manual

Epson® SureColor®
F6070 Setup Guide

2 | Unpacking and Assembling the Printer

Read all of these instructions before using your printer. Also be sure to follow all warnings and instructions
marked on the printer and in the User’s Guide.

Unpacking and Assembling the Printer

Before beginning assembly, make sure you have sufficient space to set up and use the printer. The
following illustration shows the minimum space required for using the printer:

Callout Distance

1 150 mm (5.9 in.)

2 1278 mm (50.3 in.)

3 1413 mm (55.6 in.)

4 150 mm (5.9 in.)

5 600 mm (23.6 in.)

6 1768 mm (69.6 in.)

7 10 mm (0.4 in.)

Unpacking and Assembling the Printer | 3

When choosing a place for the printer, leave adequate room for easy access and ventilation. Avoid locations
subject to direct sunlight, excessive heat, humidity, or dust. Be sure the printer is placed on a flat, stable
location that can support 198 lb (90 kg).

Caution: Six people are required to unpack and install the printer.

You need a large floor space to assemble the printer and stand, so be sure to prepare a large, clear area
before unpacking them. Also make sure you save the box and packaging in case you need to ship the
printer later.

The following items should be included with your printer:

Printer

Printer

Software and guides

Roll paper adapter

Power cord

4 | Unpacking and Assembling the Printer

Stand

Horizontal strut

Legs

Hex wrench

The items below can be found in the “Ink Supply System Cover 2” box.

Mounting brackets

Assembling the Stand | 5

Assembling the Stand

Unpack the stand and make sure you have all of these items:

.

Note: You will also need a hex screwdriver.

1.

Remove the tape from the horizontal strut. Slide the horizontal strut into both of the legs as shown.

6 | Assembling the Stand

2. Use the long end of the hex wrench to tighten the pre-placed screws on each side of the horizontal

strut.

3. Remove the four screws as shown.