DYMO Rhino 6000 Quick Start Guide

English

Figure 1

Power adapter

RHINO 6000 label printer

CD-ROM

Two R HINO

Quick Start and Quick Reference Guides

USB cable

label cassettes

Battery pack

Quick Start Guide

Follow these steps to install your RHINO 6000 label printer and software, and
print your first label.

1. Unpacking your printer

NOTE Do not plug the printer into your computer until asked to do so during the

software installation.

1 Unpack your label printer and save the packing materials.

2 Make sure you have all the items shown in Figure 1.

2. Connecting the power

Figure 2

Figure 3

The label printer can operate using the rechargable battery pack or the AC power
adapter. For temporary backup power, six AA alkaline batteries can be used.

To charge the battery pack the first time you
use the printer, insert the battery pack and plug
in the power adapter. Charging the battery
pack the first time takes approximately eight
hours. Recharging the battery pack will take
approximately two hours.

To insert the battery pack

1 Remove the battery compartment cover.

See Figure 2.

2 Insert the battery pack into the battery

compartment.

3 Replace the battery compartment cover.

To connect the power adapter

1 Plug the power adapter into the power

connector on the bottom of the printer.
See Figure 3.

2 Plug the other end of the power adapter

into a power outlet.

2