Dymo 420P User Manual
Quick Start Guide
®
LabelManager
High-Performance Portable Label Maker with PC or Mac® Connection
420P
Figure 1
Warranty card
USB cable
Charging adapter
Quick Start Guide
D1 label cassette
Lithium-ion battery
LabelManager 420P Label Maker
Quick Start
Make sure you have all the items shown in Figure 1. (Labels included in the
package may vary.)
warranty
card
Insert
-
.
,
+
–
Shift
%
For complete information on using your label maker, download the full
LabelManager 420P User Guide from the Support section of the DYMO Web site
at www.dymo.com.
1
Become familiar with the features shown in Figure 2.
Figure 2
7
1
6
2
3
4
5
Figure 3
1
Battery compartment
2
Cutter button
3
Label exit slot
4
Power connector
5
USB connector
6
Label compartment
7
Cleaning tool
Inserting the Battery
To insert the battery
1 Slide the battery compartment cover
away from the label maker. See Figure 3.
2 Insert the battery into the battery
compartment.
3 Replace the battery compartment cover.
To charge the battery
1 Plug the charging adapter into the power
connector on the top of the label maker.
2 Plug the other end of the charging adapter into a power outlet.
NOTE The charging adapter is only used for recharging the battery; the
charging adapter cannot be used to power the label maker.
2
Inserting the Label Cassette
Figure 4
Label
guides
Ribbon
rewind
spool
Figure 5
Figure 6
Your label maker uses DYMO D1 label cassettes.
To insert the label cassette
1 Lift the label cassette cover to open the label
compartment. See Figure 4.
2 Make sure the tape and ribbon are taut
across the mouth of the cassette and
that the tape passes between the label
guides. See Figure 5.
If necessary, turn the ribbon rewind
spool clockwise to tighten the ribbon.
3 Insert the cassette and press firmly until
the cassette clicks into place. See
Figure 6.
4 Close the label cassette cover.
Printing Your First Label
The first time you turn on the power, you are
asked to select the language and label width.
These selections remain set until you change
them.
To set up the label maker
1 Press Power to turn on the power.
2 Select the language and press OK.
3 Select the width of the label cassette currently in the label maker and press OK.
3
Loading...