
INSTALLATION/OWNER’S MANUAL
AM/FM/Cassette Marine Receiver

MXC22
Install mounting sleeve into radio opening, bending tabs to secure.
Remove knobs, faceplate and DIN mounting adapters from unit.
Install unit into kit or radio opening from behind. Adjust rear shaft nuts to
correct depth. Install faceplate and knobs.

MXC22
Remote Turn-On
Connect to amplifier or power
antenna. Insulate wire if not used.
RCA Cable
(sold separately)
Antenna
Connector
BLUE
Rear Preamp Output
Connect to amplifier RCA Input
GREY
Ground
Connect to vehicle
chassis ground.
BLACK
Accessory
Connect to existing ignition
circuit or switched 12 volt source.
RED
Right
Gray/Black (-)
Gray (+)
Left
White/Black (-)
White (+)
AMP
3 AMP
AGC Fuse
.5 AMP
AGC Fuse
When replacing fuses, make sure new

MXC22
knob clockwise or eject cassette to

MXC22
to activate and deactivate bass boost
Adjust balance by turning
The cassette will automatically begin playback.
button all the way in to stop and
button half way in to fast forward.
again to resume playback.
knob to select desired station.
during FM tuner operation to select
to select between FM and AM bands. The

MXC22
This warranty gives you specific legal rights.
You may also have other rights which vary from
year from the date of the original purchase.
without charges, subject to verification of the
This warranty is extended
warranties, expressed or implied, including
without limitation the implied warranties of

Toll Free: 1-866-382-5476
Signal-to-noise:
3 amp fast blow AGC, .5 amp fast blow AGC
Frequency response:
Tuning range:
Frequency response:
Tuning range:
Frequency response:
Total system power:
Power output:
Power supply:
Speaker output impedance:
Fuses:
Dimensions: