Doro AFTI 40 User Manual
AFTI 40
Hotel Telephone
English
User guide
1 Hook switch
2 Mute Button
3 Volume Control for Handset
4 Speaker
5 Redial Button
6 Recall (R) Button
7 Speaker button and LED
8 Volume Control for Speaker
9 MW Indicator
10 Direct Memory Buttons
11 Extension Port
12 Store Button
13 Ringer Switch
14 Recall Time Selector
15 MW Selector Switches
English
www.doro.com 3
Operation
Connection
1. Connect the curly cord to the handset and to the socket marked
q
.
2. Connect the telephone cord to the socket marked T, and then to the telephone
network socket. The modular plug will click when correctly put into place.
3. Pick up the handset and listen for the dial tone.
IMPORTANT!
The earpiece of the handset may attract small ferromagnetic objects such as staples and pins, care
should be taken when placing the handset near these items.
Wall Mounting
To wall-mount the telephone, rst detach the table support by placing thumbs at either
end of the support and pushing towards the rear/top side of the telephone. It can
now be mounted directly to an existing wall plate or by xing two screws in the wall,
positioned vertically 100 mm apart. These screws will t into the two ‘keyholes’ at
the back of the telephone.
Hearing Aid Compatible
This telephone is hearing-aid compatible. Select the T mode on your hearing aid to
enable this feature.
Group Listening
During a call, it is possible to activate the Group Listening function by pressing s.
With this function activated, the call can be heard from the speaker on the base unit
as well as from the handset. That way, anyone in the same room as the base unit will
be able to hear both parties and follow the conversation.
1. Dial the number as usual.
2. Once the call has been connected, press s to activate the Group Listening
function. The conversation can then be heard via the speaker. The speaker
indicator will illuminate while the Group Listening function is active.
3. Adjust the volume, if needed, using the volume control on the side.
4. To deactivate the Group Listening function, press s once again.
The speaker can also be used for hands free dialling. Press s, then dial the number and pick up the
handset when the call is answered. Remember that there is a microphone in the handset only.
English
4 www.doro.com
Operation
Mute Button
The microphone is disabled while the z button is held down.
Redial Button
If the number dialled is engaged, or if you wish to redial the last number dialled, lift
the receiver (or press the s button) and press the redial button r.
Volume Controls
The handset earpiece volume may be adjusted during a call using . Press the
right side of the button to increase the volume, the left side to decrease it.
The base speaker volume is adjusted with the control on the side of
the base.
Labels/protective cover
A set of labels are included with this product. The Hook Switch memory label can
be used for displaying information of a more temporary kind, whereas the label
under the protective cover is to be used for more permanent information, such as
instructions regarding room service, wake-up calls, laundry, etc.
To reduce the possibility of tampering with the label or its information, the
protective cover is designed to be quite difcult to remove. Remove it by pressing
the button located under the table support (after detaching the support). Keep the
button depressed, while pulling the cover upward.
To remove the Hook Switch label, use a thin instrument to remove it from its holder,
and to put it back in. The Hook Switch itself cannot be opened.
Connection of additional equipment
Additional equipment such as modems or cordless phones can be connected to this
telephone via the socket on the right side of the base.
Two methods of operation can be selected by using the 1:2 switch located on the
underside of of the base:
1. allows for single line parallel operation. For example, a computer modem can be
operated through the telephone but only one device can be operated at a time,
either the modem or the telephone.
2. allows for two line operation where a computer modem can be connected via
the telephone and both devices can be used at the same time. The network wall
socket must have two lines connected.
Loading...