DiGiCo DiGiGrid MGB-MGO User Manual
DiGiGrid MGB/MGO Quick Setup Guide
Registration
You must register your DiGiGrid MGB/MGO to get the software, drivers and any licenses needed.
To register your device, log into your Waves account at www.waves.com
Software Download
Go to Waves.com > Downloads > Hardware Drivers
Download the latest version for Mac or PC, as needed.
Run the installer and follow the onscreen instructions.
and select either MGB or MGO.
Connections
Connect your MGB/MGO to your computer.
If you are using one MGB/MGO, connect it directly to your computer’s Gigabit Ethernet port using the
supplied cable.
If you are using multiple interfaces—two MGB/MGOs, an MGB/MGO with an additional SoundGrid
interface, an MGB/MGO with multiple computers, etc.—connect them all to a SoundGrid-compatible
switch, and connect the switch to your computer’s Ethernet port.
See http://www.waves.com/hardware/soundgrid-switches
for a list of approved switches.
Simple Recording/Playback Setup with the SoundGrid Studio Application
Use the SoundGrid Studio Application as your setup application. Refer to the following images for
configuration.
.
1
Note: The first time you run and configure your MGB/MGO, you may be prompted to update the
firmware of your device. Follow the onscreen instructions.
There are also built-in templates to assist you with configuration. Select the template that best meets
your setup. For recording using a single MGB or MGO, select “MGB MGO REC-PB Standalone.” If you are
using two devices, select “2x MGB MGO REC-PB Standalone.”
Finally, check in the PATCH tab that your MGB/MGO is patched to the driver. If you selected one of the
preset templates, this should be all done. If you adjusted the number of driver channels, you may need
to patch additional channels.
Note: Depending on the number of channels you’re recording or playing back and on the computer
you’re using, you might need to raise your network and/or driver buffer-size setting in the Settings page
(PC) or directly in your DAW (Mac).
2
Loading...