WARNINGS/IMPORTANT SAFEGUARDS
• Read these instructions carefully.
• This appliance is intended for household
use only. It must not therefore be used for
other purposes, modified or tampered
with in any way.
• Before use, make sure the mains voltage
corresponds to the voltage indicated on
the rating plate on the bottom of the
appliance.
• Connect the appliance to an efficiently
earthed socket with a minimum current
rating of 10 A only. It is not necessary to
earth double insulated appliances (see
symbol on rating plate).
•When not in use or before cleaning or
maintenance, always unplug the appliance from the mains socket.
• DO NOT wash the appliance with triethylene or other solvents.
• DO NOT unplug the appliance by pulling
the power cable or the appliance itself.
• DO NOT leave the appliance turned on
when unattended. Keep away from children and unfit persons.
• DO NOT run the appliance over the
power cable to avoid damaging the cable
insulation.
• DO NOT vacuum up inflammable or corrosive liquids.
• DO NOT vacuum up matches, ash or
cigarette ends when still lit.
•Vacuuming up large quantities of ash or
particularly fine dust could reduce the
efficiency of the filtering system.
• Do not use the appliance if it appears to
be faulty.
•Take the utmost care when using the
appliance to clean stairs.
• For repairs or to purchase tools, contact
an authorised Customer Service Centre
only.
• Bear in mind that a considerable quantity
of air is given off from the air outlet grill
during use. This could be unpleasant if
directed at people, particularly the face.
The manufacturer reserves the right to modify
appliances and tools without warning.
Original spare parts and tools should be
used to maintain the efficiency of your
appliance. Failure to do so INVALIDATES the
guarantee.
ASSEMBLY AND PREPARATIONS
FOR USE AS A WET & DRY
VACUUM CLEANER
Important: during assembly and preparation for use, make sure the appliance is
UNPLUGGED from the mains.
• Release the cover by pulling the clips out-
wards (fig.1).
• Remove the diffuser cone, suction conve-
yor and, finally, the bottom plate (fig. 2).
•Turn the appliance upside down and fix
the four castors in place by pushing them
into the holes in the bottom of the drum
(fig.3).
• Make sure the polyurethane filter is in
place on the motor housing (fig 4).
• Insert the bottom plate J, fixing it to the
drum as shown in fig. 5.Insert the diffuser
cone H and suction conveyor I (fig. 6).
Using as a dry vacuum cleaner
•To use the appliance as a dry vacuum
cleaner, pour about two litres of water
into the drum. The water should never
reach above the bottom plate (J).
The water filters the dust, preventing it
from being dispersed in the atmosphere.
• Fasten the head back on the drum.
• Attach the hose to the suction port (fig. 7).
To remove, press the locking fins and pull
(fig.8).
• Fit one end of the telescopic tube to the
handgrip and the other to the most suita-
ble tool for the operation to be perfor-
11