Dell 1100, ML 1610 User Manual

Remanufacturing Instructions

Dell 1100 / Samsung ML 1610

For Technical Support, please call Memphis, TN at [phone] or Nashua, NH at [phone].

1. On the end cap where the contacts are
located, remove the two screws that secure
the end cap (Fig. 1).

Reference Information: Oasis Products:

Dell # 3106640 Toner: D3TN1070
Samsung # ML1610 Drum: D3DR305
Wiper Blade: D3WB20
OEM Yields: Fuse: 99FZ10
2000 @ 5% coverage

Fig. 1

2. Using a small flat screw driver, release
the locking tab on the bottom side of the
end cap (Fig. 2).

Fig. 2

Remanufacturing Instructions

Dell 1100 / Samsung ML 1610

Memphis, TN [phone]

Nashua, NH [phone]

Technical Support

© 1998 Oasis Imaging Products, Inc. Page 1 of 9

3. Using a small flat screw driver, gently
pry and remove the end cap from the
cartridge (Fig. 3).

Fig. 3

4. Remove the two screws that secure the
waste bin to the cartridge (Fig. 4).

5. The waste bin is held in place by a post
that sits in a slot on the end cap. Push the
waste bin up towards the handle to remove
the post from the slot on this end cap. Set the
waste bin to the side (Fig. 5).

Fig. 4

Fig. 5

Remanufacturing Instructions

Dell 1100 / Samsung ML 1610

Memphis, TN [phone]

Nashua, NH [phone]

Technical Support

© 1998 Oasis Imaging Products, Inc. Page 2 of 9

6. Remove the two screws that hold the
opposite end cap in place (Fig. 6).

Fig. 6

7. Use a small flat screw driver to pry up the
end cap to remove it (Fig. 7).
Set the toner hopper to the side.

8. Remove the two screws that secure the
wiper blade to the waste bin (Fig. 8).

Fig. 7

Fig. 8

Remanufacturing Instructions

Dell 1100 / Samsung ML 1610

Memphis, TN [phone]

Nashua, NH [phone]

Technical Support

© 1998 Oasis Imaging Products, Inc. Page 3 of 9