Delfield F18DR General Manual
PROJECT
ITEM #
QUANTITY |
|
DATE |
APPROVAL
F18DR
31.5” (80cm) Deep Remote Quick Glance Rail
Short Form Specifications
Exterior top is one-piece, 16-gauge stainless steel, with integral 2.12” (5.4cm) high square nosing on front. Top has a mechanically cooled refrigerated raised rail at rear with openings to accommodate 1/6 size pans. Pans and adapter bars are provided by others. Pans are recessed .38” in the front for easy access and 3.38” in the rear for proper cooling (see cross section). Rail interior is 22-gauge stainless steel. Raised rail openings have 20-gauge stainless steel hinged removable lids. Unit is equipped with separate expansion valve and on/off switch for refrigerated rail. Temperature in top opening to maintain 33°F (1°C) to 41°F (5°C), at 86°F ambient room temperature, meeting NSF7 requirements.
Exterior Back and Bottom are 24-gauge galvanized steel. Exterior ends are finished with 18-gauge galvanized steel.
Base Interior is 22-gauge stainless steel back and bottom. Base interior ends and door frames are thermoformed ABS plastic. Base is insulated with 1.5” (3.8cm) high density foamed in place polyurethane.
Door(s) have a 22-gauge stainless steel exterior front, with thermoformed ABS plastic interior liner, black recessed handle and snap in magnetic gasket which is easily replaceable. Each interior door section has (1) removable epoxy coated wire shelf.
Base has a blower coil assembly with expansion valve located behind door mullion. Base is equipped with independently controlled thermostat and solenoid valve. On/off switch for unit is located behind the hinged panel.
Unit is mounted on 6.13” (15.6cm) high adjustable stainless steel legs.
Electrical connections are 115 volt, 60 Hertz, single phase. Unit must be hard wired.
Refrigeration System Components — HFC-404A
Optional Accessories & Modifications
906A Stainless steel end
505H Stainless steel back
505F Laminate facing (full front)
906E Laminate end
905A Laminate back
1030A Cutting board (Sanalite or composite)
109 Condensate evaporator (1 per coil) for base 107F Tray rack
102 Drawers
A-(2) 19” in lieu of one door
B-(2) 27” in lieu of one door
C-(2) 32” in lieu of one door
E-(3) 19” in lieu of one door
F-(3) 27” in lieu of one door
G-(3) 32” in lieu of one door
H-(2) 24” in lieu of one door
J-(3) 24” in lieu of one door 108 Locks
120F Cold pan drain
213 *220V/50 cycle
*Inclusion of this option will alter the
electrical specifications of the unit
The Delfield Company, P.O. Box 470, Mt Pleasant, MI 48804-0470, U.S.A. • (800) 733-8821 • Fax (800) 669-0619 • www.delfield.com
Delfield reserves the right to make changes in design or specifications without prior notice. ©2001 The Delfield Company. All rights reserved. Printed in U.S.A.
F18DR
31.5” (80cm) Deep Remote Quick Glance Rail
Thermostat control for rail behind |
Thermostat control for rail behind |
||
hinged panel (hinged left) |
|
|
hinged panel (hinged left) |
|
|||
2.5
43.75
36.00
19" REF’D 19" REF’D
6.13 7.63
ELEVATION VIEW
F18DR44
Thermostat control for rail behind hinged panel (hinged left)
43.75
36.00
27" REF’D 27" REF’D
6.13 7.63
ELEVATION VIEW
F18DR60
Thermostat control for rail behind hinged panel (hinged left)
43.75
36.00
27" REF’D 19" REF’D 27" REF’D
6.13 7.63
ELEVATION VIEW
F18DR79
43.75
36.00
19" REF’D 27" REF’D
6.13 7.63
ELEVATION VIEW
F18DR52
Thermostat control for rail behind hinged panel (hinged left)
43.75
36.00
32" REF’D 32" REF’D
6.13 7.63
ELEVATION VIEW
F18DR70
Thermostat control for rail behind hinged panel (hinged left)
43.75
36.00
27" REF’D 27" REF’D 27" REF’D
6.13 7.63
ELEVATION VIEW
F18DR87
The Delfield Company, P.O. Box 470, Mt Pleasant, MI 48804-0470, U.S.A. • (800) 733-8821 • Fax (800) 669-0619 • www.delfield.com
Delfield reserves the right to make changes in design or specifications without prior notice. ©2001 The Delfield Company. All rights reserved. Printed in U.S.A.
Loading...