DE DIETRICH DKH876 User Manual
FR GUIDE D’INSTALLATION & D’UTILISATION
PSS500
LES NOUVEAUX OBJETS DE VALEUR
DE BEDIENUNGSANLEITUNG
NL GEBRUIKSAANWIJZING
IT LIBRETTO ISTRUZIONI
ES MANUAL DE INSTRUCCIONES
PT MANUAL DE INSTRUCOES
EN INSTRUCTIONS FOR USE
DA BRUGSANVISNING
Réfrigérateur-Congélateur- Cave à vin
Kühl-Gefrierschrank - Weinschranck
Tweedeurs-Koelkast - Wijnkelder
Frigorifero-Congelatore - Cantina
Refrigerador-Congelador - Bodega
Frigorifico-Congelador - Garrafeira
Fridge-Freezer- Winecellar
Køle-Fryseskab - Vinskab
2
Contents
Safety information 2
Control panel 4
First use 7
Daily use 7
Helpful hints and tips 11
Subject to change without notice
Care and cleaning 12
What to do if… 13
Technical data 16
Installation 16
Environmental concerns 17
Safety information
In the interest of your safety and to ensure
the correct use, before installing and first using the appliance, read this user manual
carefully, including its hints and warnings. To
avoid unnecessary mistakes and accidents,
it is important to ensure that all people using
the appliance are thoroughly familiar with its
operation and safety features. Save these instructions and make sure that they remain
with the appliance if it is moved or sold, so
that everyone using it through its life will be
properly informed on appliance use and safety.
For the safety of life and property keep the
precautions of these user's instructions as
the manufacturer is not responsible for damages caused by omission.
Children and vulnerable people safety
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance
by a person responsible for their safety.
Children should be supervised to ensure
that they do not play with the appliance.
• Keep all packaging well away from children. There is risk of suffocation.
• If you are discarding the appliance pull the
plug out of the socket, cut the connection
cable (as close to the appliance as you
can) and remove the door to prevent playing children to suffer electric shock or to
close themselves into it.
• If this appliance featuring magnetic door
seals is to replace an older appliance having a spring lock (latch) on the door or lid,
be sure to make that spring lock unusable
before you discard the old appliance. This
will prevent it from becoming a death trap
for a child.
General safety
Caution! Keep ventilation openings
clear of obstruction.
• The appliance is intended for keeping
foodstuff and/or beverages in a normal
household as explained in this instruction
booklet.
• Do not use a mechanical device or any artificial means to speed up the thawing
process.
• Do not use other electrical appliances
(such as ice cream makers) inside of refrigerating appliances, unless they are approved for this purpose by the manufacturer.
• Do not damage the refrigerant circuit.
• The refrigerant isobutane (R600a) is contained within the refrigerant circuit of the
appliance, a natural gas with a high level of
environmental compatibility, which is nevertheless flammable.
During transportation and installation of
the appliance, be certain that none of the
components of the refrigerant circuit become damaged.
If the refrigerant circuit should become
damaged:
– avoid open flames and sources of igni-
tion
– thoroughly ventilate the room in which
the appliance is situated
3
• It is dangerous to alter the specifications or
modify this product in any way. Any damage to the cord may cause a short-circuit,
fire and/or electric shock.
Warning! Any electrical component
(power cord, plug, compressor) must be
replaced by a certified service agent or
qualified service personnel.
1. Power cord must not be lengthened.
2. Make sure that the power plug is not
squashed or damaged by the back of
the appliance. A squashed or damaged power plug may overheat and
cause a fire.
3. Make sure that you can come to the
mains plug of the appliance.
4. Do not pull the mains cable.
5. If the power plug socket is loose, do
not insert the power plug. There is a
risk of electric shock or fire.
6. You must not operate the appliance
1)
without the lamp cover
of interior
lighting.
• This appliance is heavy. Care should be
taken when moving it.
• Do not remove nor touch items from the
freezer compartment if your hands are
damp/wet, as this could cause skin abrasions or frost/freezer burns.
• Avoid prolonged exposure of the appliance to direct sunlight.
Daily Use
• Do not put hot pot on the plastic parts in
the appliance.
• Do not store flammable gas and liquid in
the appliance, because they may explode.
• Do not place food products directly
against the air outlet on the rear wall.
2)
• Frozen food must not be re-frozen once it
has been thawed out.
• Store pre-packed frozen food in accordance with the frozen food manufacturer's
instructions.
• Appliance's manufacturers storage recommendations should be strictly adhered
to. Refer to relevant instructions.
• Do not place carbonated or fizzy drinks in
the freezer compartment as it creates
1) If the lamp cover is foreseen
2) If the appliance is Frost Free
3) If a water connection is foreseen
pressure on the container, which may
cause it to explode, resulting in damage to
the appliance.
• Ice lollies can cause frost burns if consumed straight from the appliance.
Care and cleaning
• Before maintenance, switch off the appliance and disconnect the mains plug from
the mains socket. If you cannot come to
the mains socket, interrupt the power supply.
• Do not clean the appliance with metal objects.
• Do not use sharp objects to remove frost
from the appliance. Use a plastic scraper.
• Regularly examine the drain in the refrigerator for defrosted water. If necessary,
clean the drain. If the drain is blocked, water will collect in the bottom of the appliance.
Installation
Important! For electrical connection
carefully follow the instructions given in
specific paragraphs.
• Unpack the appliance and check if there
are damages on it. Do not connect the appliance if it is damaged. Report possible
damages immediately to the place you
bought it. In that case retain packing.
• It is advisable to wait at least four hours
before connecting the appliance to allow
the oil to flow back in the compressor.
• Adequate air circulation should be around
the appliance, lacking this leads to overheating. To achieve sufficient ventilation
follow the instructions relevant to installation.
• Wherever possible the back of the product
should be against a wall to avoid touching
or catching warm parts (compressor, condenser) to prevent possible burn.
• The appliance must not be located close
to radiators or cookers.
• Make sure that the mains plug is accessible after the installation of the appliance.
•
Connect to potable water supply only.
3)
4
Service
• Any electrical work required to do the servicing of the appliance should be carried out
by a qualified electrician or competent person.
• This product must be serviced by an authorized Service Centre, and only genuine
spare parts must be used.
Environment Protection
This appliance does not contain gasses
which could damage the ozone layer, in
Control panel
Fridge Control panel
1 2 3 4 5 6 7
1 Pilot light
2 ON/OFF switch
3 Temperature regulator (warmest)
4 Temperature indicator
5 Temperature regulator (coldest)
6 Auto Fresh light
7 Auto Fresh switch
Switching on
Insert the plug into the wall socket.
Press the ON/OFF switch .
The Pilot Light will light up.
Switching off
Keep ON/OFF switch pressed for more than
5 seconds.
After that, a countdown of the temperature
from -3 -2 -1 will be shown. When “1” appears the appliance is turned off. The temperature indicator switches off. The Pilot light
switches off.
Temperature regulation
The temperature can be adjusted between
+2°C and +8°C.
By pressing the Temperature regulators, the
current temperature setting flashes on the
Temperature indicator. It is possible to modify the setting temperature only with flashed
either its refrigerant circuit or insulation
materials. The appliance shall not be discarded together with the urban refuse
and rubbish. The insulation foam contains flammable gases: the appliance
shall be disposed according to the applicable regulations to obtain from your
local authorities. Avoid damaging the
cooling unit, especially at the rear near
the heat exchanger. The materials used
on this appliance marked by the symbol
are recyclable.
indicator. To set a warmer temperature,
press warmest Temperature regulator. To
set a colder temperature, press coldest Temperature regulator. The Temperature indicator displays the newly selected temperature
for a few seconds and then shows again the
inside compartment temperature.
The newly selected-temperature must be
reached after 24 hours.
Caution! During the stability period by
the first starting the temperature
displayed can not correspond to the
setting temperature. During this time it is
possible that the temperature displayed
is lower than the setting temperature.
Temperature indicator
During normal functioning the Temperature
indicator shows the temperature inside the
fridge.
Important! Difference between the
temperature displayed and temperature
setting is normal. Especially when:
• a new setting has recently been selected.
• the door has been left open for a long time.
• warm food has been placed in the compartment.
5
Auto Fresh function
The maximum performance is obtained by
setting the Auto Freshfunction. It’s recommended when loading large quantities of
food.
You can activate the Auto Fresh function by
pressing the Auto Fresh switch.
Wine Cooler Control panel
1 2 3 4 5 6 7 10 128
1 Pilot light
2 ON/OFF switch
3 Temperature regulator (warmest)
4 Temperature indicator
5 Temperature regulator (coldest)
6 Temperature regulator (warmest)
7 Temperature indicator
8 Temperature regulator (coldest)
9 Light indicator
10 Light switch
11 Alarm reset light
12 Door alarm reset switch
Switching on
Insert the plug into the wall socket.
Press the ON/OFF switch .
The Pilot Light will light up.
Switching off
Keep ON/OFF switch pressed for more than
5 seconds.
After that, a countdown of the temperature
from -3 -2 -1 will be shown. When “1” appears the appliance is turned off. The temperature indicator switches off. The Pilot light
switches off.
Temperature regulation
By pressing the Temperature regulators, the
current temperature setting flashes on the
Temperature indicator. It is possible to modify the setting temperature only with flashed
indicator. To set a warmer temperature,
press warmest Temperature regulator. To
The Auto Fresh light will light up.
Important! The internal temperature goes
down to +2°C.
After about 6 hours the Auto Fresh function
switches off automatically.
9 11
set a colder temperature, press coldest Temperature regulator. The Temperature indicator displays the newly selected temperature
for a few seconds and then shows again the
inside compartment temperature.
The newly selected-temperature must be
reached after 24 hours.
Caution! During the stability period by
the first starting the temperature
displayed can not correspond to the
setting temperature. During this time it is
possible that the temperature displayed
is lower than the setting temperature.
Important!
If the wine cooler is switched off, the door
must be closed to ensure that the freezer is
working properly.
When switched off, the electronic control of
the appliance functions automatically and
periodically circulating the air to prevent unpleasant smells and humidity within the compartment.
Temperature indicator
During normal functioning the Temperature
indicator shows the temperature inside the
wine cooler.
Important! Difference between the
temperature displayed and temperature
setting is normal. Especially when:
• a new setting has recently been selected.
• the door has been left open for a long time.
• warm food has been placed in the compartment.
6
Door open alarm
If the door remains open for a few minutes,
the Alarm reset light will flash and an alarm
will sound.
1. Press the Door alarm reset switch to
switch off the Alarm sound.
2. Close the door and the Alarm reset light
will switch off.
Light switch and light indicator
If you would like the light to remain on, with
the door closed, it is sufficient to open and
Freezer Control panel
1 2 3 4 5 6 8
1 Pilot light
2 ON/OFF switch
3 Temperature regulator (warmest)
4 Temperature indicator
5 Temperature regulator (coldest)
6 Auto Freeze light
7 Auto Freeze switch
8 Alarm light
9 Alarm reset switch
Switching on
Insert the plug into the wall socket.
Press the ON/OFF switch .
The Pilot Light will light up.
Switching off
Keep ON/OFF switch pressed for more than
5 seconds.
After that, a countdown of the temperature
from -3 -2 -1 will be shown. When “1” appears the appliance is turned off. The temperature indicator switches off. The Pilot light
switches off.
Temperature regulation
The temperature can be adjusted between
-15°C and -24°C.
By pressing the Temperature regulators , the
current temperature setting flashes on the
Temperature indicator. It is possible to modify the setting temperature only with flashed
close the door and the light will remain ON
automatically for 10 minutes.
If you want to switch off the light before the
automatic turn off time, open the door and
push thelight switch. The light indicator will
switch off. The light has no negative effect on
the quality on the wine.
7 9
indicator. To set a warmer temperature,
press warmest Temperature regulator . To
set a colder temperature, press coldest Temperature regulator. The Temperature indicator displays the newly selected temperature
for a few seconds and then shows again the
inside compartment temperature.
The newly selected-temperature must be
reached after 24 hours.
Caution! During the stability period by
the first starting the temperature
displayed can not correspond to the
setting temperature.
Temperature indicator
During normal functioning the Temperature
indicator shows the temperature inside the
freezer.
Important! Difference between the
temperature displayed and temperature
setting is normal. Especially when:
• a new setting has recently been selected.
• the door has been left open for a long time.
• warm food has been placed in the compartment.
Auto Freeze function
You can activate the Auto Freeze function by
pressing the Auto Freeze switch.
The Auto Freeze light will light up.
Loading...