Dascom 7010 Installation Guide

7106 7206 7010

Installation Guide

WLAN Interface

EN

T

This guide explains how to install and configurate the WLAN card 043942 in your
label printer.

- 2 -

his guide explains how to install the Ethernet LAN card in your label printer.

You should conult your dealer or distributor for more information if you are not
completely sure of how to perform this operation.

Installation Guide

Caution

Always turn o the power to the printer and remove
the power cord before replacing the interface board.

Replacing the Interface Board

1. Remove the two screws that x the bracket of the parallel interface board
to the printer. Then gently pull the interface board towards you. When
you do this, be careful not catch or damage the connecting cable. Do not
pull the cable too much as this could also cause damage.

Interface board

Back of the printer

Screws

Flat interface cable

– 3 –

2. Remove the connecting cable from the interface board and reconnect the

- 3 -

cable to the connector of the new interface board.

3. Insert the interface board into the printer so that the connecting cable does
not catch on the printer. The new board is slightly larger than the original
board, so the interface cable will need to be tucked in carefully.

4. Use the two screws that you removed to re-x the bracket in place.

7106 7206

Back of printer

Interface cable

7010

Attention:

Please insert the Ethernet
board by bending the
cable as shown in the
picture.

LAN interface board

interface board

Screws

– 4 –