DAEWOO Dwf-7094 Diagram

WIRING DIAGRAM

PCB ASS’Y

APPENDIX

Wiring Diagram [Dwf-7094 non-pump]

9. PRESENTATION OF THE P.C.B ASS’Y

MESSAGE CAUSE SOLUTION

Improper installation of drain hose.

The drain hose is blocked up by foreign matter.

Drain motor is inferior.

The water tap is closed.

The water inlet filter clogged.

It passes over the 60 minutes, yet it doesn’t come to assigned water level.

Wash loads get uneven during spin.

Poor installation of the unit.

The lid is opened.

The safety switch is inferior.

The load sensing is inferior. After the load sensing operates about 15 seconds, the message is displayed during 0.5 second and water level is always fixed ‘high’.

The water level sensing is inferior.

Install drain hose properly.

Remove foreign matter from drain hose.

Change drain motor.

Open the water tap.

Clean the water inlet filter.

Check whether or not is comes to the assigned water level.

Re-set wash loads evenly.

Proper installation.

Close the lid.

Change the safety switch.

Change the P.C.B. ASS’Y.

Check the water level sensor and the contact part of the connector.

Concerning Error Message