315.228310, 315.228410, 315.228510, 113.299310, 113.299410,113.299510
Item No.
929993
Save this manual for future reference.
^ CAUTION: Read and follow
all Safety Rules and Operating Instructions before first use of this product.
Customer Help Line: 1-800-932-3188
Sears, Roebuck and Co., Hoffman Estates, IL 60179 USA Visit the Craftsman web page; www.sears.com/craftsman
SAFETY
LOOSE PARTS
PREPARATION
INSTALLATION
ALIGNMENT
972000-662
3-99
READ ALL INSTRUCTIONS
READ THESE INSTRUCTIONS AND THE INSTRUCTIONS FOR YOUR TABLE SAW THOROUGHLY before using accessories.
KNOW YOUR POWER TOOL. Read the owner's manual for the Table Saw carefully. Learn the saw's applications and limitations as well as the specific potential hazards related to this tool.
KEEP THE WORK AREA CLEAN. Cluttered work areas and work benches invite accidents. DO NOT leave tools or pieces of wood on the saw while it is in operation.
ALWAYS WEAR SAFETY GLASSES. Everyday eyeglasses have only impact-resistant lenses; they are NOT safety glasses.
ALWAYS DISCONNECT SAW FROM POWER SUPPLY BEFORE MAKING ADJUSTMENTS OR ADDING ACCESSORIES. Make sure the switch is off when reconnecting to power supply.
SAVE THESE INSTRUCTIONS. Refer to them frequently and use to instruct other users. If you loan someone this tool, loan them these instruc tions also.
Look for this symbol to point out important safety precautions. It means attention!!! Your safety is involved.
These included parts make up the the fence and rails accessory 929993. Fasteners are shown actual size,
1. Fence |
|
2. Rails |
|
A. Fence............................................................. |
1 |
A. Front rail end cap.......................................... |
2 |
B. Screw (1/4-20 x 3/8)....................................... |
2 |
B. Screw for end caps (5/32-32 x 1/2 in.)........... |
4 |
C. Fine Adjustment Knob................................... |
1 |
C. Rear rail end cap.......................................... |
2 |
|
|
D. Front rail........................................................ |
1 |
|
|
E. Rear rail......................................................... |
1 |
B.
PREPARATION
REMOVING THE SWITCH AND RAILS
■Remove the front rail end caps.
■Under the front rail, loosen the switch screws and slide the switch off of the rail. See Figure 2.
Note: Do not remove the switch screws completely. Loosening the screws will allow you to slide the switch off the front rail and the switch will be ready to install on the new front rail.
FRONT RAIL
'TABLE EXTENSION
6----------------- |
SWITCH SCREW |
SQUARE NUT
SLOT FOR BOLT |
TABLE EXTENSION |
■Remove the rear rail end caps.
■Under the table, loosen all of the hex nuts on the square head bolts that hold both front and rear rails. See Figure 3.
Note; Do not remove the hex nuts completely. Loosening the nuts will allow you to slide the rails off the table and the square head bolts will be ready for the new rails.
■Carefully slide the rails off of the bolts and the table.
Fig. 2