Kangaroo™ 924
Enteral Feeding Pump
Instructions for Use
General Programing Instructions:
Close roller clamp on pump set.
Load set per arrow diagram on pump. (Do not overstretch tubing.)
Optional Feature - Press “VTBD” button and set by either turning the knob or using the increase/decrease buttons. (Only use “VTBD” if you want to stop and alarm once a set amount of formula is delivered).
Fill or spike feeding bag prior to setting up pump.
Press on and wait while a system check is performed.
Open the roller clamp.
Slowly open clamp and fill entire line with fluid; leaving a few drops in the drip chamber.
Check “VOL CLR” light or press ”VOL” then “VOL CLR” to clear volume, (if necessary).
Press “Start/Hold”.
Close roller clamp.
Set feed rate using either increase/decrease buttons or turning side knob.
To change rate press “Start/ Hold” and set rate by pressing increase/decrease buttons on the front panel.
COVIDIEN, COVIDIEN with logo and ™ marked brands are trademarks of Covidien AG or its affiliates.
©2008 Covidien AG. All rights reserved.
H-6210-5M-0308
15 Hampshire Street |
1.800.962.9888 |
www.covidien.com |
Mansfield, MA |
508.261.8000 |
|
02048 |
|
|
|
|
|
Loading...