CompuSTAR RF-2W1B-SP User Manual

Firstech, LLC. | 1
8102REUCL001200 // FT-1B2W Guide REV1
QUICK START CARD
2 WAY 1 BUTTON REMOTES
Tap this button for 1 second to lock your doors and/or arm your vehicle. Upon confirmation, the Lock LED will flash and remote will chirp once.
Tap this button twice within 1 second to unlock your doors and/or disarm your vehicle. Upon confirmation, the Unlock LED will flash and remote will chirp twice.
Hold this button for 3 seconds to start your vehicle. Your vehicle’s parking lights will flash once and/or siren will chirp once for confirmation. Upon confirmation, the Start LED will flash and remote chirp once. It will then chirp three times to confirm your vehicle has started. Repeat and your vehicle will shut off.
Valet Mode: If your remote start is not working, you may be in Valet Mode. Your parking lights will also not flash. Your doors will still lock and unlock. To exit Valet Mode,turn the vehicle’s ignition On and then tap this button 5 times, waiting a second between each tap. Your vehicle will flash the parking lights twice and exit Valet Mode. You can also exit Valet Mode by turning the ignition On and then tapping the foot brake 10 times or reprogramming your remote(s).
To reprogram your remote first cycle the key in the ignition 5 times within 7 seconds. Parking lights will flash. After that tap the Lock button on your remote. Repeat for any additional remotes. If you receive two parking light flashes, your system has exited remote programming mode and you must retry.
2W1B_QuickCard 130827.indd 1 2013/8/27 19:04:18
EVENT LEDS
LED
COLOR
LED
DURATION
REMOTE
CHIRPS
Runtime Remaining: 100% Red
Once Every
5 Seconds
3 Times
Runtime Remaining: 50% Red
Runtime Remaining: 25% Red
Runtime Remaining: 60 Sec Red
Once Every 2
Seconds Lock Confirmation Blue 1 x 1 x
Unlock Confirmation Blue 2 x 2 x
Start/Stop Confirmation Blue
Once On/
Twice Off
Once On/
Twice Off
All Error Confirmations Red
3 Times 3 Times
Arming/Locking While Trigger is Open
Red
Low Battery Warning Blue Fade
PARKING LIGHT FLASHES REMOTE START ERROR
3 then 1 1: Motor running
3 then 2 2: Key in ignition on position
3 then 3
3: Door open (manual transmission only)
3 then 4 4: Trunk open
3 then 5 5: Foot brake on
3 then 6 6: Hood open
3 then 7
7: Reservation off (manual transmission only)
3 then 8 8: Tach or voltage sensing failure
3 then 9 9: FT-DAS sensor shutdown
3 then 10 10: System is in Valet Mode
START ERROR CODESLEDS
Firstech, LLC. | 2
QUICK START CARD
2 WAY 1 BUTTON REMOTES
Register online at www.compustar.com within 10 days of purchase to activate your new remote’s warranty.
Questions/comments? Contact us at 888-820-3690 from 8 AM to 5 PM PST. Also please visit www.compustar.com for a complete user’s manual.
2W1B_QuickCard 130827.indd 2 2013/8/27 19:04:19
Loading...