Compustar R7000 User's Manual

2WFMR 2WFMR-2
G
Télécommande
/
e
bidirectionnelle FM
UID
E D
E
L ’ U T I L I S A T E U R
2WFMR/2WFMR-2
U
S
E
R
By Firstech, LLC.
www
nd
Two-Way FM Remote
G
.compustar
UID
.org
E
TABLE OF CONTENTS
- Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
- Remote-Pager: 2WFMR,2WFMR-2nd w/LCD. . . . . . . . . . . . . . . . .
- CompuGLO color LCD (Liquid Crystal Display) . . . . . . . . . .
- Remote-Pager Button Functions . . . . . . . . . . . . . . . . . . . . . . . . .
- Remote-Pager Learn Routine . . . . . . . . . . . . . . . . . . . . . . . . .. . .
-
Auto-start Function . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
- Reservation Mode. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
-
Canceling Reservation Mode. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
-
Valet Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
- Safety Shutdown Features . . . . . . . . . . . . . . . . . . . . . . . . . .
-Turbo Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
-
2nd Car Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
-
Limited Lifetime Consumer Warranty . . . . . . . . . .
. . . . . . . . . . . Page12
. . . .
. . . .
. . . .
. . . .
. . . .
. . Page11
Page 4 Page 4
Page 5 Page 6
Page 7 Page 7
Page 8 Page10
Page10 Page10-
Page11
Page 2 Page 3
Safety Information
CompuGLO color LCD
Please take these safety precautions into consideration under the following conditions:
1. Servicing the vehicle
When servicing (i.e. changing the oil, washing your car) your automobile, the C o m p u S t a r
system should be in Valet Mode. There is a safety shutdown switch
under the hood that deactivates the remote starter function if the hood is open. However, if the switch has been damaged or the switch has been installed
improperly, the vehicle may start when Button
II
is pressed for 2 seconds even if
the hood is open.
2. Loaning your vehicle to others
Whenever you loan your vehicle to an individual who is not familiar with
C o m p u S t a r
,
please put the vehicle in Valet mode. This will prevent the vehicle loaner from accidentally activating the
C o m p u S t a r
auto-security system.
3. For manual transmission vehicles
If the CompuStar system is installed in a manual transmission vehicle, extra precautions are required because the CompuStardoes not monitor the gear shifter :
U
I m p o r t a n t !
nder normal circumstances, Reservation Mode is cancelled
w
hen a door or hatchback opens. Please verify that the opening of any door or hatchback cancels Reservation Mode. If any of the doors or hatchback are not monitored by CompuStar because of improper installation or a faulty dome light switch, do not use the CompuStar and take your vehicle immediately to the dealer for repair. Do not set Reservation Mode if the window(s) are open or if there is anyone inside the vehicle, this includes animals. Remote start installation in a manual transmission vehicle with a convertible top is
Remote-Pager : 2WFMR, 2WFMR-2
The model name, 2WFMR, 2WFMR-2ndstands for
Remote with Liquid Crystal Display
.
not recommended.
nd
w/LCD
Two Way Frequency Modulated
This transmitter allows you to activate multiple functions by pressing different combinations of the 4 buttons on the unit.
The remote-pager comes with CompuGLO, which is a unique color LCD display that visually tells you the security status of your vehicle as long as you are in range. There are differing icons that will appear on your CompuGLO LCD indicating what your vehicle is currently doing.
Auto Turbo Timer Passive
2WFMR 2WFMR-2
Icon
Auto
Turbo
nd
2
Timer
Passive
Indicates that Auto Mode is on. Indicates that Turbo Mode is on. (2WFMR) Indicates that 2ndVehicle Mode is on. ( 2WFMR-2nd) Indicates that Timer Mode is on. Indicates that Passive Arming Mode is on.
Auto 2
Explanation
n d
Timer Passive
nd
Indicates that the Shock Sensor has been triggered.
Indicates that you are in Valet Mode. Indicates that your parking lights are flashing.
Indicates that your siren is turned on when locking or unlocking your vehicle.
Indicates that someone is paging you from your vehicle. Indicates that your car is locked or unlocked.
Indicates that your remote-pager is transmitting signals to the controller unit.
Indicates that Vibration Mode is on.
Page 4 Page 5
Displays remaining battery life. Displays running time left - each bar represents 25% of the running time.
Indicates that your door is open. Indicates that your vehicle has auto-started properly or that the ignition is on.
Indicates that your trunk is open.
Remote-Pager Button Functions
Remote-Pager Learn Routine
The Compustar system will allow up to three remotes to be programmed to one vehicle. Please perform the following procedure to add or reprogram additional
remotes.
Step1 :
Activate Valet/Programming mode by manually turning the ignition
on and off five times with the key within a 7 second period. The parking lights will flash once with successful completion of this step.
(between Acc and On)
1
2 3 4
5 6 7 8 9
10 11 12
13
14 15 16
Note : " "
"
( )"Represents simultaneously pressing the buttons.
"
( )"Represents simultaneously pressing the buttons for 2 seconds.
Button
I
I I
I I I I V
I-
II-
III-
IV-
( I + I I )
( I + I I I )
( I I + I I I )
( I I + I V )
( I I I + I V )
( I + I I I ) -
( I + I I ) -
( I + I V ) -
PressedFor
1/2 sec
1/2 sec 1/2 sec 1/2 sec
2 sec 2 sec
2 sec
2 sec 1/2 sec 1/2 sec
1/2 sec 1/2 sec
1/2 sec
2 sec
2 sec
2 sec
Lock / Arm Unlock / Disarm
AUX 1 AUX 2
Query Function Auto Mode - on/off Auto-start Function - on/off Trunk Release
Panic, Press buttonIto shut off siren. Siren Chirp – on/off
Valet Mode – on/off Passive Arming – on/off Timer Start Mode – on/off
Turbo Mode - on/off (2WFMR) 2ndCar - on/off (2WFMR-2nd)
Shock Sensor – on/off Programming Menu 1
Programming Menu 2
Represents pressing the button for 2 seconds.
Function
Step2 :
Note :
Within a 7 second period after cycling the ignition for the 5
press button I. The parking lights will flash once to confirm that the
transmitter has been programmed. You can continue programming
additional remotes. The parking lights will flash two times when the programming mode has expired.
If you lose your remote after you have armed the vehicle, use your key
t h
time,
to open the door. The siren will go off. Turn the ignition on then off, 5 times with your key to shut down the alarm and put the system into
valet mode. You can cancel the valet mode with a remote later on. See:
Note :
Valet mode,
(Siren duration is 30 to 60 sec depending on the options set at the time
on page 10.
of initial installation.)
Auto-Start Function
Press button Remember, that a manual key in the ignition is required to drive the car.
For manual transmission vehicles, please use reservation mode. Press button
The engine will run 15 or 25 minutes (25 or 45 min for diesel) depending on preset options at the time of installation, and then shut off.
II
for 2 seconds to auto-start an automatic transmission engine.
I I
for 2 seconds in order to turn off an auto-started car.
Page 6
Page 7
A n t i - G r i n d
The anti-grind circuit (an optional feature provided by your installer) prevents you from engaging the starter on a remote-started vehicle.
Flashing Battery icon during remote start. The battery icon flashes while the engine is running . Each of the 4 bars of the battery indicates
25% of the remaining engine running time.
Diagnosing problems with Auto-Start
If there is a problem in auto-starting your vehicle,the CompuStar system will do one of two things; if it fails for any of the reasons listed in the table below, it will flash the
parkinglights three times then flash the error number. Otherwise, it will attempt to start the vehicle three times. If, after three times, the vehicle will not start or stay
running, the CompuStar system will shut down. In either case, please see your installer to resolve the situation.
Error Number
(# of times parking lights flash)
1 2 3 4 5 6 7
Reservation Off (Manual Transmission Only)
Error Reason
Engine On
Key On
Door Open
Trunk Open
Brake On
Hood Open
Important requirements to activate Reservation Mode
- The transmission must be in the NEUTRAL position.
- The vehicle windows must be rolled up.
- Do not set reservation mode with people in the vehicle.
- Do not auto-start the vehicle with people in the it.
Activating Reservation Mode
Step1 :
Step2 : Step3 : Step4 : Step5 :
Your vehicle is now ready for auto-starting. However, the reservation mode will be cancelled if the door is opened or the CompuStar system is put in Valet mode
after the reservation has been set. Once cancelled, you will have to start the vehicle with the manual key and repeat the above 5 steps if you want to restore
reservation mode.
Important!
Compustar system will lock/arm the vehicle. Take care to not lock your keys inside.
After arriving at your destination, and BEFORE TURNING
YOUR ENGINE OFF,place the transmission in the Neutral position.
Activate the parking brake. Remove your foot from the foot brake. Remove the key from the ignition, and the engine will remain running. Exit the vehicle and close the door within two minutes after
a c t i v a t i n gthe parking brake. The engine will shut off and reservation mode for the remote starter is now complete.
When the vehicle shuts off after reservation mode, the
(Manual Transmission only)
Reservation Mode
(manual transmission only)
In order to auto-start your manual transmission vehicle, you must first set the CompuStar system to Reservation Mode before leaving your vehicle. The purpose
of Reservation Mode is to leave the transmission gear in the neutral position when you leave your vehicle. Reservation mode is intended for use on MANUAL
TRANSMISSIONS ONLY and NOT FOR AUTOMATIC TRANSMISSIONS. Reservation Mode must be engaged each and every time you leave your manual
transmission vehicle in order to auto-start it.
Note :
This system is not recommended for installation on manual transmission
vehicles with removable tops.
Page 8
Important!
If you try to auto-start the vehicle when reservation mode
has not been set, the auto-start feature will not work. When you press the auto-start button, the remote will beep three times.
The vehicle parking lights will flash three times, pause, then flash seven times.
Page 9
Loading...
+ 9 hidden pages