Page 1
10/100/1000 Mbps Intelligent Redundant Ring
Gigabit Switch with Optional PoE+
CNGE4+2SMS[POE][HO]/M
-40˚ TO +75˚ C
FLEXIBILIT Y
GUARDIAN
The ComNet CNGE4+2SMS[POE][HO]/M is a six port intelligent switch with light management
functionality. It provides four 10/100/1000Base-T(X) copper ports and two 100/1000Base-FX SFP*
ports. The CNGE4+2SMS[POE][HO]/M provides exclusive functionality for easy field deployment
including DIP switch based operation of RSTP for creating redundant network topologies as well
as preventing network video flooding of multicast traffic using IGMP snooping. Ports 1 through 4
can optionally supply up to thirty (30) watts of power per port based on the IEEE 802.3at standard.
An optional High Output (HO) version is also available that can supply up to sixty (60) watts of PoE
from ports 1 through 4. This product is fully compatible with the ComNet exclusive CopperLine®
SFP modules for operation over extended distance UTP or Coax cable. The ComNet exclusive Port
Guardian feature provides additional cyber security protection by enabling physical port lockout in
the event that an existing cable is disconnected and prevents a potential network incursion using
common spoofing techniques. The intrusion event is reported back to the operator using SNMP.
FEATURES
› Several features can be enabled with no programming
required:
- RSTP (Rapid Spanning Tree Protocol)
- SMS Multicast Flooding Prevention
(Star/Linear topologies only)
- Dual Redundant SFP Mode
- IGMP Snooping
› 10/10 0/1000 Mbps Ethernet
• 4 × 10/100/1000 BASE-T/TX electrical ports
• 2 × 100/1000 BASE-FX SFP ports (individually DIP switch
selectable)
› Electrical ports support Auto-Negotiation for 10Mbps,
100Mbps or 1000Mbps, full duplex or half duplex data.
› SFP Ports support 100 or 1000 Mbps full duplex data
› SFP Ports compatible with CopperLine CL-SFP modules
› IEEE802.3at Power over Ethernet (PoE+)
› 30W or 60W PoE+ on Ports 1-4
†
› 2 Duplex contact closures
› Automatic MDI/MDI-X crossover
› Designed to meet full compliance with the environmental
requirements (ambient operating temperature, mechanical
shock, vibration, humidity with condensation, highline/low-line voltage conditions and transient voltage
protection) of NEMA TS-1/TS-2 and the Caltrans
Specification for Traffic Signal Control Equipment.
› PoE status monitoring & automatic reboot function
†
†
PORT
30W
†
60W
†
› Event notification through SNMP traps and Relay Output
› Voltage transient protection on all power and signal input/
output lines provides protection from power surges and
other voltage transient events.
› RSTP supported
› IGMP v2 snooping supported
› Redundant AC/DC inputs for uninterrupted operation in the
event of a loss of operating power or a power supply failure
› Supports LLDP (Link Layer Discovery Protocol)
› SNMP v1/v2c for network management
› May be DIN-rail mounted by the addition of ComNet model
DINBKT2 or DINBKT4 adaptors.
› Port Guardian prevents network intrusion through intelligent
physical port lockout
› Lifetime Warranty
› Made in the USA
APPLICATIONS
› 10/100/1000 Mbps Ethernet
› Perimeter Protection Surveillance Systems
› IP Video
* SFP = Small Form-Factor Pluggable Module
† CNGE4+2SMSPOE/M or CNGE4+2SMSPOEHO/M models only
4 + 22ALL GIGABIT
LIFETIME WARRANTY WWW.COMNET.NET TECH SUPPORT: 1.888.678.9427
Page 2
CNGE4+2SMS[POE][HO]/M
A
SPECIFICATIONS
10/100/1000 Mbps Intelligent Redundant Ring
Gigabit Switch with Optional PoE+
Data
Data Interface Ethernet
Data Rate 10/100/1000 Mbps
IEEE 802.3 Compliant
Full Duplex or Half Duplex Electrical Ports/Full
Duplex Optical Port
Electrical CNGE4+2SMSPOE/M Ports 1-4: 30 W Max
CNGE4+2SMSPOEHO/M Ports 1-4: 60 W Max
Connectors
Optical¹ Requires selection of sold-separately SFP modules.
See ComNet data sheet for number
and description of SFP modules.
Serial Mini USB
I/O Terminal Block
Power Terminal Block
Data RJ45
Network Redundancy
STP / RSTP
Management
SNMP SNMP V1/2c
HTTP Web GUI Configuration Interface
CLI Serial Command Line Interface
Switch Properties
Switching Latency 7 µs
Switching Bandwidth 12 Gbps
MAC Table 1K
Processing Store-and-Forward
Contacts (PoE Models Only)
Response Time 25ms typical (network dependent)
Input/Output Channels 2
Inputs 2 × Dry Closure
Outputs 2 × Form A contacts (Rated 1A @ 24 VDC, non-
resistive loads)
Power
Operating Voltage Dual 48 to 56 VDC PoE, 9 to 36 VDC
or 24 VAC non PoE
Current Draw 246 W max with PoE, 6W max w/out PoE
Current Protection Automatic Resettable Solid-State Current Limiters
PoE Pin Assignment RJ45 port support s IEEE802.3at
End-point Positive (VCC+): RJ45 pin 1, 2
(RJ45 pin 1,2 and 4,5 on 60W ports)
Negative (VCC-): RJ45 pin 3, 6
(RJ45 pin 3,6 and 7,8 on 60W ports)
Electrical & Mechanical
Indicating LEDs Optical Link/Data Activity
Electrical Link/Data Activity
Power PoE Status
Circuit Board Meets IPC Standard
Size 4.1 × 3.7 × 2.2 in (10.4 × 9.4 × 5.6 cm)
Surface Mount Wall or Flat Surface Screw Attachment
Shipping Weight <2 lb / 0.9 kg
Environmental
MTBF >100,000 hours
Operating Temp -40˚ C to +75˚ C
Storage Temp -40˚ C to +85˚ C
Relative Humidity 0% to 95% (non-condensing)²
Software Features
STP/RSTP (IEEE 802.1D/w)
Port Configuration, Status, Statistics
PoE Configuration, Status, Health Check
SNMP
Enable/Disable Ports
IGMP v2 Snooping
Ethernet Standards
IEEE 802.3 for 10BASE-T
IEEE 802.3u for 100BASE-TX and 100BASE-FX
IEEE 802.3z for 1000BASE-X
IEEE 802.3ab for 1000BASE-T
IEEE 802.1D for STP (Spanning Tree Protocol)
IEEE 802.1w for RSTP (Rapid Spanning Tree Protocol)
IEEE 802.1AB for LLDP (Link Layer Discovery Protocol)
IEEE 802.3at for Power Sourcing Equipment (PSE) and PoE (≤ 30 W per port)
IEEE 802.3x Flow Control and Back Pressure
GENCY COMPLIANCE
LIFETIME WARRANTY WWW.COMNET.NET TECH SUPPORT: 1.888.678.9427
Page 3
CNGE4+2SMS[POE][HO]/M
10/100/1000 Mbps Intelligent Redundant Ring
Gigabit Switch with Optional PoE+
ORDERING INFORMATION
Part Number Description
CNGE4+2SMS/M Small Surface Mount 6 Port Gigabit Ethernet Self-managed Switch 2 SFP FX, 4TX, 2 Cont act Closure
CNGE4+2SMSPOE/M Small Surface Mount 6 Port Gigabit Ethernet Self-managed Switch 2 SFP FX, 4T X with 30W of PoE+ power, 2 Contact Closure
CNGE4+2SMSPOEHO/M Small Surface Mount 6 Port Gigabit Ethernet Self-managed Switch, 2 SFP FX, 4TX with 60W of PoE+ power, 2 Contact Closure
Included Accessories DC Plug-in Power Supply, 90-264 VAC, 50-60 Hz (included with CNGE4+2SMS only, for benign 0 to 50ºC applications only. Hardened power supply
available, consult factory)
Options Power Supply for PoE Models (Extra charge, consult factory)
User-selection of SFP or CopperLine CL-SFP modules (Extra charge, see SFP data sheets for product numbers and compatibility before ordering)
[2] Add suffix ‘/C’ for Conformally Coated Circuit Boards to extend to condensation conditions (Extra charge, consult factory)
DIN-Rail Mounting Adaptor Plate Kit – With mounting hardware (Optional, order model DINBKT2 or DINBKT4)
[1] Multimode fiber needs to meet or exceed fiber standard ITU-T G.651. Single mode fiber needs to meet or exceed fiber standard ITU-T G.652
This product requires a fiber installation with a minimum 30 dB connector return loss. The use of Super Polish Connectors is recommended.
Complies with FDA Performance Standard for Laser Products, Title 21, Code of Federal Regulations, Subchapter J.
In a continuing effort to improve and advance technology, product specifications are subject to change without notice.
TYPICAL APPLICATIONS
1 Gbps Fiber Ring Example
Managed
Switch with
CNGE4+2SMS/M
with 2 × SFP-6
RSTP
1000FX Fiber
IP
Network
Power
100 Mbps Legacy Copper Ring
Managed
Switch with
CNGE4+2SMS/M
with CL-SFP3 and SFP-3
RSTP
100FX Fiber
IP
Network
Power
1000FX Fiber
CNGE4+2SMSPOE/M
with 2 × SFP-6
6
5
4
3
2
1
.
.
.
100FX Coax
Power
CNGE4+2SMSPOE/M
with 2 × CL-SFP3
6
5
4
3
2
1
.
.
.
Power
1000FX Fiber1000FX Fiber
6
5
4
3
2
1
6
100FX COAX100FX UTP
5
4
3
2
1
CNGE4+2SMSPOEHO/M
with 2 × SFP-6
.
.
.
.
.
.
Power
CNGE4+2SMSPOEHO/M
with 2 × CL-SFP3
Power
6
5
60W PoE30W PoE
4
3
2
1
60W PoE30W PoE
444
.
.
.
111
6
5
60W PoE30W PoE
4
3
2
1
60W PoE30W PoE
444
.
.
.
111
3 CORPORATE DRIVE
8 TURNBERRY PARK ROAD
© 2017 Communica tion Networ ks. All Right s Reserve d. “ComNet ” and the “ComNe t Logo” are regis tered tra demarks of Comm unication Net works.
|
DANBURY, CONNECTICUT 06810
|
GILDERSOME
|
MORLEY
|
|
USA
T: 203.796.5300
|
LEEDS, UK LS27 7LE
|
F: 203.796.5303
|
T: +44 (0)113 307 6400
|
|
F: +44 (0)113 253 7462
TECH SUPPORT: 1.888.678.9427
|
INFO-EUROPE@COMNET.NET
|
INFO@COMNET.NET
13 Apr 2017
Loading...