Comelit KAE5063 Technical Manual

EN

TECHNICAL

MANUAL

Three-family kit

KAE5063

2

Warning

Table of contents

Package contents ............................................................................ 3

Transformer ...................................................................................... 4

Description ...............................................................................................4

External unit ..................................................................................... 5

Description ...............................................................................................5

Installation ................................................................................................6

Inserting nameplates ..........................................................................6

Internal units .................................................................................... 7

Description ...............................................................................................7

Installation ................................................................................................8

Operating distances ........................................................................ 9

Wiring diagrams............................................................................... 9

Standard system and 1 additional door-entry phone connection

variant........................................................................................................9

System expansion: additional external unit and internal unit ............10

Intended use

This Comelit product was designed for use in the creation of audio and video communication systems in residential,

commercial or industrial settings and in public buildings or buildings used by the public.

Installation

All activities connected to the installation of Comelit products must be carried out by qualified technical personnel, with

careful observation of the indications in this manual.

Wires

Disconnect the power supply before carrying out any operations on the wiring.

Use wires with a cross-section suited to the distances involved, observing the instructions provided in the system
manual.

We advise against running the system wires through the same duct as the power cables (230V or higher).

Safe usage

To ensure Comelit products are used safely:

• carefully observe the indications provided in the manual.

• make sure the system created using Comelit products has not been tampered with / damaged.

Maintenance

Comelit products do not require maintenance aside from routine cleaning, which should be carried out in accordance

with the indications provided in the manual.

Any repair work must be carried out

• for the products themselves, exclusively by Comelit Group S.p.A.,

• for systems, by qualified technical personnel.

Disclaimer

Comelit Group S.p.A. does not assume any responsibility for

• any usage other than the intended use

• non-observance of the indications and warnings contained in this manual.

Comelit Group S.p.A. nonetheless reserves the right to change the information provided in this manual at any time and

without prior notice

3

Package contents

ET9211

2702W 2702W 2702W

1200

ET5100

KAE5063

x1x1 x1

External unit ET9151 ET9161

×3

2702W Internal unit

×1

1200 Transformer

3

1

6

4

12 V~

230 V~

1.

2.

4

Transformer art. 1200 with 230V primary, 12V AC / 15 VA secondary winding for continuous use.

Dimensions: 53x95x65 mm (3 DIN modules).

1. 230 V digital input

2. Secondary 12 V AC output

Disconnect the power supply before carrying out any maintenance procedures.

The electrical system of the building must be fitted with an omnipolar mains switch with a contact opening of
at least 3 mm, which is capable of isolating the power supply of the device.

Place the protection back over the terminals and close the inspection door after every procedure.

Transformer

Description