Comelit KAE5062 Technical Manual

EN

TECHNICAL

MANUAL

Technical manual for two-family Kit Art. KAE5062

2

Warning

• Install the equipment by carefully following the instructions given by the manufacturer and in compliance with the
standards in force. Do not tamper with the internal elements offering protection against short circuits and overcurrents.

• All the equipment must only be used for the purpose it was designed for. Comelit Group S.p.A. declines any
responsibility for improper use of the apparatus, for any alterations made by others for any reason or for the use of
non-original accessories or materials.

• All the products comply with the requirements of the 2014/30/EU and 2014/35/EU directives. This is proved by the
CE mark on the products themselves.

• Do not route the riser wires in proximity to power supply cables (230/400V).

• Installation, mounting and assistance procedures for electrical devices must only be performed by specialised
electricians.

• Do not press and hold the audio hook while the handset is lifted.

• Disconnect the power supply before carrying out any maintenance procedures.

• The electrical system of the building must be fitted with an omnipolar mains switch with a contact opening of at least
3 mm, which is capable of isolating the power supply of the device.

• Place the protection back over the terminals and close the inspection door after every procedure.

Table of contents

Warning ............................................................................................ 2

Package Contents ........................................................................... 3

Transformer Art. 1200...................................................................... 4

Description ...............................................................................................4

External unit Art. ET5002 ................................................................ 5

Description ...............................................................................................5

Installation ................................................................................................6

Replacing the nameplate holders .......................................................6

Internal unit Art. 2701W................................................................... 7

Description ...............................................................................................7

Installation ................................................................................................8

Operating distances and standard diagram ................................. 9

Wiring diagram for standard system and 1 additional door-entry phone

connection variant ...................................................................................9

Operating distances .................................................................................9

3

Package Contents

This manual includes information regarding system configuration and customisation which may be perceived as necessary by
the installer.

2701W 2701W1200

ET5002

KAE5062

×1 ×1 ×

1

ET5002 - External unit

×2

2701W - Telephone

×1

1200 - Transformer