How it Works
Chauvet DJ
Loading...
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
Loading...
Loading...
Intimidator Spot LED 350
User manual
21 pgs1.13 Mb0
Table of contents
Loading...

Chauvet DJ Intimidator Spot LED 350 User manual

User Manual
TABLE OF CONTENTS
1. Before You Begin .............................................................................. 3
Claims ........................................................................................................................ 3
2. Introduction ....................................................................................... 5
3. Setup .................................................................................................. 7
Fuse Replacement ..................................................................................................... 7
Power Linking............................................................................................................. 8
Orientation ................................................................................................................. 9
Rigging ....................................................................................................................... 9
4. Operation ..........................................................................................10
Starting Address ....................................................................................................... 11
DMX Personalities .................................................................................................... 11
14-CH ....................................................................................................................... 12
8-CH ......................................................................................................................... 14
Sound-Active Mode .................................................................................................. 15
Automatic Mode ....................................................................................................... 15
Manual Pan/Tilt Operation ....................................................................................... 15
Pan/Tilt Angle Range ............................................................................................... 15
Display ..................................................................................................................... 15
Master/Slave Mode .................................................................................................. 16
5. Technical Information ......................................................................18
6. Technical Specifications ..................................................................19
Page 2 of 21 Intimidator™ Spot LED 350 User Manual Rev. 8
What Is

Unpacking
Instructions

included accessories) appear damaged from
damage not related to shipping,
Text
1–512
A range of values
50/60
A set of values of which only one can be chosen
Settings
A menu option not to be modified
Menu > Settings
A sequence of menu options to be followed
<ENTER>
A key to be pressed on the product’s control panel
ON
A value to be entered or selected

Symbols

Critical installation, configuration, or operation information. Not damage to the product, or cause harm to the operator.
Document
The information and specifications contained in this document are subject to change
assumes no responsibility or liability for any errors or omissions
reserves the right to update the existing

1. BEFORE YOU BEGIN

Included

Claims

Conventions
• Intimidator™ Spot LED 350
• Hanging Bracket with Mounting
Hardware
Carefully unpack the product immediat ely and check the container to make sure all the parts are in the package and are in good condition.
If the box or the contents (the product and shipping, or show signs of mishandling, notify the carrier immediately, not Chauvet. Failure to report damage to the carrier immediately may invalidate your claim. In addition, keep the box and contents for inspection.
For other issues, such as missing components or parts, or concealed damage, file a claim with Chauvet within 7 days of delivery.
Convention Meaning
Symbol Meaning
• Power Cord
• Warranty Card
• Quick Reference Guide
Information
following these instructions may make the product not work, cause
Important installation or configuration information. The product may not function correctly if this information is not used.
Useful information.
without notice. Chauvet that may appear in this manual. Chauvet document or to create a new document to correct any errors or omissions.
You can download the latest version of this document from www.chauvetlighting.com.
© Copyright 2015 Chauvet. All rights reserved.
Electronically published by Chauvet in the United States of America
Author Date Editor Date
R. Isenstadt 02/23/15 A. Leon 02/25/15
Intimidator™ Spot LED 350 User Manual Rev. 8 Page 3 of 21
Product at a
x
P
x
P
P
P
P
x
P

Safety Notes

information about the mounting, usage, and maintenance
Do not touch the product’s housing when operating because it may be very hot.
disconnect from power via breaker or by unplugging it.
Glance
Use on Dimmer Outdoor Use Sound-Activated DMX Master/Slave
These notes include important of this product; read before using the product.
• This product is not intended for permanent installation.
• Always connect the product to a grounded circuit to avoid the risk of electrocution.
• Always disconnect the product from power before cleaning or replacing the fuse.
• Avoid direct eye exposure to the light source while the product is on.
• Make sure the power cord is not crimped or damaged.
• Never disconnect the product from power by pulling or tugging on the cord.
• If mounting the product overhead, always secure to a fastening device using a
safety cable.
• Make sure there are no flammable materials close to the product when operating.
•
• Always make sure that the voltage of the outlet to which y ou are conne cti ng the
product is within the range stated on the decal or rear panel of the product.
• The product is for indoor use only! (IP20) To prevent risk of fire or shock, do not expose the product to rain or moisture.
• Always install the product in a location with adequate ventilation, at least 20 in (50 cm) from adjacent surfaces.
• Be sure that no ventilation slots on the product’s housing are blocked.
• Never connect the product to a dimmer.
• Make sure to replace the fuse with another of the same type and rating.
• Never carry the product from the power cord or any moving part. Always use the
hanging/mounting bracket or the handles.
• The maximum ambient temperature (Ta) is 104 °F (40 °C). Do not operate the product at higher temperatures.
• In the event of a serious operating problem, stop using the product immediately.
• Never try to repair the product. Repairs carried out by unskilled people can lead to
damage or malfunction. Please contact the nearest authorized technical assistance center.
• To eliminate wear and improve its lifespan, during periods of non-use completely
Auto Programs Auto-ranging Power Supply Replaceable Fuse User-Serviceable
Keep this User Manual for future use. If you sell the product to another user, be sure to give this document to the next owner.
Page 4 of 21 Intimidator™ Spot LED 350 User Manual Rev. 8

2. INTRODUCTION

Product Overview

Control Panel and Button Menu
DMX Out
Safety Loop
Fuse Holder
DMX In
Power In
Power Out
Intimidator™ Spot LED 350 User Manual Rev. 8 Page 5 of 21

Product Dimensions

Page 6 of 21 Intimidator™ Spot LED 350 User Manual Rev. 8

AC Power

ranging power supply and it can work with
circuit breaker, power outlet, and
(circuit breaker or fuse).
an appropriate electrical ground to avoid the risk of
a rheostat (variable resistor) or dimmer circuit, even
Fuse

3. SETUP

The Intimidator™ Spot LED 350 has an auto­an input voltage range of 100–240 VAC, 50/60 Hz.
To determine the product’s power requirements ( wiring), use the current value listed on the label affixed to the product’s back panel, or refer to the product’s specifications chart. The listed current rating indicates the product’s average current draw under normal conditions.
• Always connect the product to a protected circuit
Make sure the product has electrocution or fire.
• To eliminate wear and improve its lifespan, during periods of non-use
completely disconnect from power via breaker or by unplugging it.
Never connect the product to if the rheostat or dimmer channel serves only as a 0 to 100% switch.
1. Disconnect the product from power.
Replacement
2. Using a Phillips #2-head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove the blown fuse.
4. Replace with a fuse of the same type and rating.
5. Screw the fuse holder cap back in place and reconnect power.
• Disconnect the product from power before replacing the fuse.
• Always replace a blown fuse with another of the same type and rating.
Intimidator™ Spot LED 350 User Manual Rev. 8 Page 7 of 21
Loading...
+ 14 hidden pages
Buy Points How it Works FAQ Contact Us Questions and Suggestions Privacy Policy Cookie Policy Terms of Use