Chamberlain C940 User Manual

N2966

professional

C940

C943

C945

C943

C940

945

One device of your choice

DO NOT operate your garage door unless it is in full view and clear of obstruction and is properly adjusted. No one should enter or leave the garage whilst the door is in motion.

o not allow children to operate push

D button(s) or remote. Do not allow children to play near the door.

433MHz Rolling Code Remote Controls

C943 – Three-channel rolling code remote control C945 – Three-channel rolling code mini remote control

940- Single channel rolling code remote control

Suits: Merlin Professional products garage door openers. MT60, MT600/MT1000, MT5580, MR600a/800a and Merlin Gate Motors MGS300/400, MGA300 and MGS300/500/1000

Chamberlain does not recommend or endorse this accessoryʼs use with products other than garage door or gate motors.

MT5580

ADDING REMOTES MT SERIES

1. Press and hold the selected remote push button you

2. Press and release the orange "Learn" button (1) on the opener panel. The opener light will flash

once. Release the remote push button. If no light bulb is installed, two clicks will be heard.

ADDING REMOTES MR SERIES

1. Press and hold the selected remote push button you

2. Press and release the purple "Learn" button (1) on

If you release the remote control push button before the opener light or LEDs flash, the opener has not accepted the code.

CHOOSING A BUTTON

You can use any of the three buttons to activate your door. If you have multiple doors or an automated gate you may use one of the other two buttons to activate it, provided you have a compatible receiver. For further details please refer to our web page.

To Erase All Programmed Remotes/Codes

Press and hold the "Learn" button (1) on the opener panel until the indicator light turns off (about 6-10

wish to open the door.

seconds).

Note: This procedure erases all codes from the operators memory.

. To add or re-program valid remotes into your opener,

follow the procedure laid out in “ADDING REMOTES”.

NOTE: FOR GATE MOTORS CONSULT OWNERʼS MANUAL.

MT5580

MR800a/ MR600a

wish to open the door, the orange LED will flash.

the opener panel. The openerʼs courtesy LEDs will flash once. Release the remote push button.

FOR GATES SEE GATE USER MANUAL

MT600/ MT1000

MT60

Replacing Batteries

Model C943/C940:

Insert batteries 10A20 (CR2032) x2 positive sideup.

Model C945: Insert 1x battery 10A20

(CR2032) positive side

To replace cover, snap shut along both sides.The lithium batteries should produce power for up to 5 years. To replace batteries, use a coin, the visor clip or screwdriver blade to pry open the case, as shown (“Open” location is stamped on back.)

Chamberlain Australia Pty Ltd PO Box 1446 Lane Cove NSW 1595

Chamberlain New Zealand Ltd P.O. Box 100-221 North Shore 0745 www.chamberlainanz.com

MT60

MR800a/ MR600a