CENTRAL BRASS 0072-A-Q Installation Manual

CONCEALED LEDGEMOUNT

KITCHEN SINK F AUCET

8-Inch Centers

Quarter-Turn Compression Stem Units

0072 - A-Q Series

100072-A-Q Series
200072-A-Q Series

Faucets with lever, wrist or elbow
handles and compression or ceramic
stem cartridges are ADA compliant.

CENTRAL BRASS MFG CO

2950 East 55th Street, Cleveland, Ohio 44127

Phone: [phone] Fax: [phone] Email: sales @CentralBrass.com

022503 I-0000

www.CentralBrass.com

Certified to
ANSI/NSF 61 Section9

CENTRAL BRASS

INSTALLATION INSTRUCTIONS

1. Place two locknuts onto faucet body one on hot and one on cold side. Screw locknut down to

lower portion of threads, do not tighten. Place gasket on each locknut.

2. Place large locknut on center spout portion of faucet body and screw down onto base. Place
gasket over center locknut.

3. Insert faucet body in sink from underside.

4. Apply a thin coat of plumbers putty to the bottom edge of the center escutcheon and tighten

down until snug with sink.

5. Assemble spout to faucet body . T ighten spout nut carefully .

6. Loosen center escutcheon until clearance between escutcheon and spout nut is minimum.

Tighten center locknut on underside of sink.

7. Apply a thin coat of plumbers putty to the bottom edge of the corner escutcheons and tighten
down until snug. T ighten locknuts under sink.

9. Connect supply lines to bottom inlets of valve body . Hot to left side.

10. Turn on supply lines. Check all connections for leakage.

11. Remove spout by loosening spout nut, replace spout and remove aerator. Turn on hot and

cold water for one minute to flush out dirt and sediment that might have accumulated during
installation.

12. Reconnect spout and replace aerator.

13. Check all connections for leakage.

CENTRAL BRASS MFG CO

2950 East 55th Street, Cleveland, Ohio 44127

Phone: [phone] Fax: [phone] Email: sales @CentralBrass.com

022503 I-0000

www.CentralBrass.com