Canon iR1210, iR1230, iR1270F, iR1310, iR1330 ir1200s-009
...
Service Bulletin
Issued by Canon Europa N.V.
COPIER
Model:
Location:
Subject:
Reason:
Detail:
The description is corrected shown in 2.2.1 "Removing the Image Processor PCB" in Chapter 5 of the Service
Manual as follows.
<Before correction>
1) Remove the rear cover. (See 2.1.1.1)
2) Remove the printer controller PCB. (See 2.2. 5)
3) Remove the retainer for the flexible cable used to connect the analog processor PCB and the image
processor PCB.
4) Remove the core, and disconnect all connectors from the image processor PCB [1].
5) Remove the 6 screws [2], and detach the image processor PCB [1].
Caution: For installation, fasten the core to the upper position with the part [3] and f i x the cable with the
part [4].
iR1210/iR1230/iR1270F
iR1200/iR1300 Seri es SERVICE MANUAL (Rev.0) (FY8-13HU-000)
Correction of “Removing Image Processor PCB”.
Correction of the Service Manual
No.:
DATE:
iR1200S-009
(FF-T01-L6-000063-01)
20.12.02
<After correction>
1) Remove the rear cover. (See 2.1.1.1)
2) Remove the Printer controller PCB. (See 2.2.5)
3) Remove the right cover. (See 2.1.1.2)
4) Remove the screw [1], and detach the ADF harness cover [2].
F05-202-01A
5) Remove the 2 harness retainers [3].
6) Remove t he screw [4] and disconnect the grounding wire from the co re.
7) Disconnect t he 2 connector s (J310/J311) [5].
F202-01B
8) Pull both connectors (J310/J311) [5], throug h the upper cove r [6].
F202-01C
9) Remove the retainer [7] for the flexible cable used to connect the analog processor PCB and the image
processor PCB.
- 1 / 2 -
10) Remove the core [8] and disconnect all connectors from the image processor PCB [9].
11) Remove the 6 screws [10], and detach the image processor PCB [9].
F202-01D
Caution: For installation, fasten the core to the upper position with the part [11] and fix the cable with the
part [12].
F05-202-02
Changed locations of the Service Manual are written in the attachment with red-letter.
iR1200S-009
- 2 / 2 -
Loading...