Canon IP 1500 User Manual

1
Installation Manual on
Continuous ink supply system (CISS)
For printer Canon IP 1500
Thank you for using the “INKSYSTEM” Continuous ink supply system. It is the best device for an inkjet printer, and it will definitely decrease your printing costs. Before using this system, please read this manual carefully. The pictures in this manual may be different with the real ones. Here just for your reference.
I. Inspection & Unpacking
1. Accessories
1) Continuous ink supply system …………………………………………..1
2) Air Filter …………………………………………………………………1
3) Sponge …………………………………………………………………...1
4) Injector …………………………………………………………………..1
5) Long needle ……………………………………………………………...1
6) Short needle ……………………………………………………………...1
7) Protection clamp …………………………………………………………1
8) Installation Manual ………………………………………………………1
9) Product Warranty ………………………………………………………...1
Pic. 1-1 Pic. 1-2
2. Inspection before installation
Check whether CISS is pulling out, if tube is disconnected.
Please contact local distributor if have found problems.
II. Test printer
1. Check whether printer conditions are normal.
2. Enter nozzle test option (2-1), print nozzle test sheet to see whether nozzle is
normal (2-2, 2-3).
INSTALLATION MANUAL ON CISS FOR PRINTER CANON IP 1500
2
Pic. 2-1 Pic. 2-2 Pic. 2-3
3. If printer is alright, please print a picture to see the result.
Ill. Installation Procedures
1. Make the system ready
Put this system on the right side of the printer, tidy up ink flow tubes (3-1-1), pull out all air plug and replace them with air filter with bigger side downward (keep air plug for next use) (3-1-2). Move tube valve to close position, if you do not close this valve, ink maybe flow back, leak, or mis-color.
Pic. 3-1-1 Pic. 3-1-2
2. Install the CISS cartridges
Turn the printer on, open it’s cover, cartridge holder will move to the "cartridge change" position, plug the power source off (3-2-1), take the original cartridge off. Take cartridge red color, clean them for next use). Install the cartridges according to the color order; press back the cartridge cover (3-2-2).
Pic. 3-2-1 Pic. 3-2-2 Pic/ 3-2-3
INSTALLATION MANUAL ON CISS FOR PRINTER CANON IP 1500
3
3. Fix iron rack
Use forceps to bend the rack (3-3-1) (This is to let the sponge sticker stick to the printer body tightly). Tear off the cover of sticker, stick the rack to the printer body strictly according to the indicated position and size (3-3-2. 3-3-3), do not twist the ink tube (3-3-4).
Pic. 3-3-1 Pic. 3-3-2 Pic. 3-3-3
4. Check tube length
Move cartridge holder to the left side (3-4-1), then right side (3-4-2) and check whether ink tube is too long or too short. Move cartridge holder to the cartridge­changing place and check whether Ink tube will fall on the paper board.
Pic. 3-4-1 Pic. 3-4-2 Pic. 3-4-3
5. Adjust the ink tube length
If step 4 is ok, then there is no need to go through this step.
If the tube length is too short then lengthen it (3-5-1, 3-5-2), if too long then shorten (3-5-3, 3-5-4). If the tube falls down, you need adjust the angle of sticker to prevent falling (3-5-5).
Pic. 3-5-1 Pic. 3-5-2
INSTALLATION MANUAL ON CISS FOR PRINTER CANON IP 1500
Loading...
+ 5 hidden pages