Broan SP200 Specifications

SPECIFICATION SHEET

MODELS SP100, SP140 & SP200
SINGLE-PORT REMOTE
IN-LINE VENTILATORS

Provides continuous, low-level ventilation, improving
overall indoor air quality.

FEATURES

BLOWER:

• High pressure, centrifugal blowers accommodate many
ducting configurations

• Motors designed for continuous operation

• Permanently-lubricated motors assure worry-free
operation

• Permanent Split Capacitor (PSC) motors are used for
quiet operation and low power consumption

• Plug-in motor rated at 120 VAC, 60 HZ operation

• HVI certified to assure consistent operating performance

HOUSING:

• Rugged 20 gage steel housing finished with electrically­bonded epoxy paint

• May be installed in virtually any orientation - ceiling, wall
or floor

• In-line installation assures quiet operation

• Easily removable panel permits quick access to blower
for cleaning and servicing without disturbing ductwork

• 6" round inlet and outlet for easy duct connections

• All wiring and ductwork can be connected from the
outside of the housing - no need to remove access panel
or blower.

TYPICAL SPECIFICATION

The in-line ventilator shall be Broan Model SP100 (Broan
Model SP140) (Broan Model SP200).

Ventilator to have steel housing with cover that permits
quick access to blower for cleaning or service without
disturbing ductwork. All wiring to be done from outside of
housing. Unit will accomodate 6" round, insulated flexible
duct.

Blower shall be designed for continuous operation using a
permanently lubricated, PSC (Permanent Split Capacitor)
motor and a centrifugal blower wheel.

Unit to be U.L. listed, CSA certified, and HVI certified.

Broan-NuTone LLC, 926 West State Street, Hartford, WI 53027 (1-800-637-1453)

REFERENCE QTY. REMARKS Project

Location

Architect

Engineer

Contractor

Submitted by Date

10D 99041953E

PERFORMANCE RATINGS - MODELS SP100, SP140 & SP200

AMCA LICENSED PERFORMANCE

Model CFM @ Static Pressure (Ps - Inches of H20) Nominal Duct

No. 0.0 0.2 0.25 0.4 0.6 0.8 Volts Amps RPM Size
SP100 120 110 107 97 81 - 120 .5 2850 6" RD
SP140 164 150 145 133 115 103 120 .8 2900 6" RD
SP200 224 210 207 195 181 170 120 1.3 3000 6" RD

The performances shown are with inlet grille, backdraft damper and outlet duct. RPM shown is nominal and the performance is based on actual speed of test.

"Broan-NuTone LLC certifies
that the models shown herein
are licensed to bear the AMCA
Seal. The ratings shown are
based on tests and procedures
performed in accordance with
AMCA Publication 211 and
comply with the requirements
of the AMCA Certified Ratings
Program."

WEIGHT

MODEL SHIPPING

NO. WT.

SP100 15.8 lbs.
SP140 16.2 lbs.
SP200 16.3 lbs.

SELECTION GUIDE

DWELLING SIZE RANGE (Sq. Ftg.)

(include finished basement area)

MODEL

SP100
SP140
SP200

*AC/HR = Air Changes per Hour Based on 8' ceilings, CFM @ .25Ps
SQ. FT. X 10.764= M

.50 AC/HR* .35 AC/HR* .30 AC/HR*

1500 2140 2500
2100 3000 3500
3000 4285 5000

2

SP100

HVI PERFORMANCE

MODEL CFM

NUMBER .2" Ps .4" Ps

SP100 110 120
SP140 150 140
SP200 210 200

HVI-2100 CERTIFIED RATINGS
comply with new testing technologies
and procedures prescribed by the
Home Ventilating Institute, for off­the-shelf products, as they are
available to consumers. Product
performance is rated at 0.1 in. static
pressure, based on tests conducted
in AMCA’s state-of-the-art test
laboratory. Sones are a measure of
humanly-perceived loudness, based
on laboratory measurements.

STATIC PRESSURE (IN. WG.)

SP140 SP200

STATIC PRESSURE (IN. WG.)

AIR FLOW RATE (CFM)

Broan-NuTone LLC, 926 West State Street, Hartford, WI 53027 (1-800-637-1453)

AIR FLOW RATE (CFM)

STATIC PRESSURE (IN. WG.)

AIR FLOW RATE (CFM)