Bowflex VersaTrainer Owner's Manual

Versatrainer Assembly Instructions

1-800-2669-3539

Vertical Extrusion

Power Rod Assembly

1) Rotate extrusion to upright position.

2) Lift pivot arm until extrusion screw holes align.

3) Turn 3/8" x 4" bolt into bottom hole. (Bolt is
preplaced in hole for you)

4) Place 3/8" x 3 1/4" bolt into top hole and tighten.

5) Tighten securely using enclosed allen wrench.

Pivot Arm

3/8" x 3 1/4" bolt

3/8" x 4" bolt

#12 sheet metal screw

6) Slide Power Rod Assembly onto top of vertical main frame.
Make sure that it is all the way on so that the holes on each
side line up. Secure the two parts together by tightening
four of the #12 sheet metal screws through the four
holes (two on each side) on the black Power Rod Assembly.

Vertical Main Frame