Boss Audio BV9965I User Manual

09

ACCESSORY

INSTRUCTIONS

Accessory

User Manual

Wire

USB Cable

Keys

Install metal bar

Remote controller

Warranty card

IPOD Cable

DVD Parental control function

DVD Parental control function

DVD Parental control function：The default set
for DVD is #8 adult, which means all grades of
DVD can be read without entering password.To
change the default grade,you need to follow the
below procedure: Press SETUP button on the
remote, display will show the system set up menu

and the submenu,

0000, you will be able to choose the DVD
grade as default.

select password and enter

Quantity

2PCS

1PC

1PC

2PCS

1PC

1PC

2PCS

1PC

17

INSTRUCTIONS

TROUBLE SHOOTING

PROBLEM

Cannot power on

After ignition switch
off ,setting
information all lose

Poor performance
of radio station

Connot load disk

Cannot play disc

Cannot switch
language/subtitle

No image

Cannot watch
image during
driving

Check fuse

Some factors cause MPU
wrong operation

Change battery or fuse

Weak signal

There is a disk inside

Disc is scratched

Put wrong side of disc into
the unit

Lens is dirty

There is only one language/
subtitle in disc

Other factors cause MPU
wrong operation

It’s not allowed to watch image
during driving

CAUSE SOLUTION

Change fuse same as the old one

Press RES button on the panel by
penpoint, then, power on

Reset information and save

Move the car to another place, then research

Remove disc before inserting another one

Change new disc

Insert in the disk with sign side up

Clean lens by lens clean disc

If disc is not with multi-language/subtitle,
it cannot switch language/subtitle

Press [RES] button on the panel by
penpoint, then, power on

Park the car in a safe place, put the car stall
in “ P ” postion, pull up the hand brake,
parking brake wire must be grounded

CONTENTS

Panel Introduction

Basic Functions
Remote Control Function

Turn the Unit On/Off

Enter into the Main Interface
Play SD card/USB memory device

Radio Function Operation

Disc Function Operation

Play/Eject Disc

DVD/VCD Disc Playback

CD Disc Playback

MP3/WMA Format Disc Playback

Touch Menu Function
iPod function operation (Optional)

External input operation (Optional)

Other Function Operations

Rear view function

General setting

Time setting

Language Setup

Video Setup

Audio setting

Steering Wheel Setup(Optional)

Touch calibration

Diagram

Wiring

Trouble shooting

Accessory

DVD Parental control function

INSTRUCTIONS

02
03
05
07
07
07

08

09

09

09

09

09
09

11

11

11

11
12

12

12

12

13

13
13
15

16

17

17

16

01

INSTRUCTIONS

INSTRUCTIONS

PANEL ARRANGEMENT

1
2

3

4

M

ODE

E

T

U

M

5 6 7

1/

2/RPT 3/RDM

8 9 10 11 12

WIRING DIAGRAM

This player is equipped with ISO standard connector, please follow below instruction:

● Red - ACC ON (+12V)

● Yellow – 12 V Constant

● Black – Ground wire

● Blue - Power Antenna / Remote Amp Turn On

● Orange – Back-Up Camera Trigger (+)

16

15

14

13

4/

5/

6/

● Grey/Grey black - Right front speaker (+/-)

● White/White black - Left front speaker (+/-)

● Purple/Purple black - Right rear speaker (+/-)

● Green/Green black - Left rear speaker (+/-)

● Pink – Parking Brake (-)

M

MUTE

Note:

O

DE

1/

2/RPT 3/RDM

4/

5/

6/

The “PARKING BRAKE” wire must be connected to the parking brake system
of your car. When the parking brake is engages, the LCD will be allowed to view
your video. If not, the screen will produce an image saying, “PARKING BRAKE”.
This is a safety feature designed for the driver not to watch a video while driving.
The video output on this unit will not be affected by this.

SD

17 18

02

RESET

15

INSTRUCTIONS

INSTRUCTIONS

BASIC FUNCTION

3.RELEASE Button

Press this button to release the panel.

4

5

14

6. SEEK Knob/( / )/ (SEEK+/SEEK-)/(SEEK/SEEK)(Speed forward/backward/Select station/song)

In radio mode, press/rotate the knob to select station upward/backward. Long press/rotate the knob to
automatically scan station.
In playback mode, short press/rotate the knob to select song upward/backward,long press/rotate it to
achieve speed forward/backward function.

7

8

9

03

INSTRUCTIONS

INSTRUCTIONS

10.

11

12

13

14

15

16

17

18

Audio setting

Click icon on setup interface to access audio setting interface, as shown in
diagram:
You can turn on or turn off the existing functions on audio setting interface.

Steering wheel setting

I. Click icon on setup interface so as to access steering wheel setting interface.
II.Connect anode and cathode of direction control wire of the car with anode and cathode of
direction control wire of this device, and press the buttons on steering wheel one by one
and record the corresponding sequence and functions, then click [Allocation].

III. Click the button of steering wheel needs to be allotted so as to select the corresponding
setting function, such as volume +.

IIII. Buttons on steering wheel shall display the corresponding functions, such as volume + .

To modify function settings, repeat procedures 3~4. Click [Enter] to save the settings.
To reset functions, click [Reset] icon, all the settings set before shall be cleared, repeat

procedures 3~4 for resetting.

Touch calibration

If touch calibration error occurs, you can adjust the touch coordinate by “Touch calibration”.
Click icon on setup interface, input password [888888] to confirm to access touch

calibration interface, as shown in below diagram:

Touching methods

Use touch pen to click the center of “+” icon, and move along with center of “+” icon so as
to calibrate the screen. It shall automatically save data and exit after screen calibration.
Please accurately click all positions on screen, or the accuracy of touch calibration shall be
affected.

right(PIC 1)

PIC 1

04

13

INSTRUCTIONS INSTRUCTIONS

Access setup interface

Click [Setup] icon on main interface to access setup interface.

General setting

Click icon on setup interface to access general setting interface, as shown in below
PIC 1 diagram:
In general setting interface, you can select to turn on or turn off the existing functions.
You can set wallpaper and opening picture you like and check version number of DV/DC,
click icon to browse up/down.

Wallpaper selection

Click icon on wallpaper bar , icon shall pop up, click it to

direction

select wallpaper.

Opening picture

Click icon on opening picture bar , icon shall pop up, click it

direction

to select opening picture.

Time setting

Click

icon on setup interface to access time setting interface, as shown in below

PIC 2diagram:
Click icon on time bar time setting interface shall display, as shown in

below PIC 3 diagram:
Click icon beside hour and minute to separately set hour and minute.

REMOTE CONTROL FUNCTION

28

PIC 2PIC 1

Language Setup

During use, you can select your familiar language to display menu by language setup.
Click icon on setup interface to access language setting interface, as shown in right
(PIC 4) diagram:

Click the corresponding icon on the language bar desired to be set so as to switch
the language type, when there are more than 3 languages, direction icon shall pop up,
click it to select your familiar language.

Video setting

Click

icon on setup interface to access video setting interface, as shown in right

(PIC 5) diagram:
At video setting interface, you can adjust brightness, contrast, saturation and hue of the video.

PIC 4

12

PIC 3

PIC 5

28

DSP

05

INSTRUCTIONS INSTRUCTIONS

iPod function operati on

Connect to iPod first, touch [iPod] icon on main interface to access iPod interface, as
in below diagram.

Fast forward play/Fast backward play

Play/Pause

shown

Volume adjustment knob

28.DSP

Press this button to show the time.

Stop

Previous Song/next Song

Back to the
main interface

External input operation

Connect the video input plug with external video input jack, and connect the audio input
plug with external audio input jack.

Touch [Input] icon on main interface to access external input interface.

Audio You can adjust the

volume, bass, pitch for input audio.

You can adjust the speaker volume by adjusting the front and back,left and right column.
Video You can adjust the brightness, contrast, saturation and hue for input video.

You can also choose the video standard mode.

NO VIDEO SIGNAL

Other functions
Rearview function

In any running state, the video signal can switch to reverse video state when reversing the
car, and the system shall return to its initial running state after reversing the car.

Warning

Do not rely on CCD system completely,

driving

.Back rearview system only assists in driving. As the distance range of rearview

please make sure you use your direct eyesight while

system is limited, completely relying on the rearview system during driving may cause
accidents.

06

Reverse field simulation

11

Rearview backup image

INSTRUCTIONS INSTRUCTIONS

Access next menu

Touch it to access the next menu interface.

Time setting

Touch this button to access time setting interface.

Stereo on/off

Touch it so as to turn on/off stereo.

Return to root menu

Touch this icon, it shall return to root menu of disk in DVD state and access PBC
menu playing in VCD state. All chapters in the disk shall be displayed on the interface,
touch the chapter icon directly for playing.

Access title menu

Press this button to return to title menu of the disk. Directly click menu bar at title
menu interface for playing.

Repeat play

In playing state, touch this button to start repeat play function: Chapter repeat
Title repeat Off.

During VCD playing, this function only works when PBC is off.

Language selection

Touch this button to select language.

Digit keyboard

Touch this button and digit keyboard shall appear, click number buttons directly to
select tracks for playing.

Randomly play

Touch this button to instantly play each song. Press again to back to the normal play.

Zoom in/Zoom out image

Touch this button to zoom in /zoom out the image.

Turn on/off Host

When the ignition switch is put in ACC or ON position,Press[ ] button on the front panel
to turn on the unit.After the host starts, hold [ ]button for 3 seconds , the host will turn off.

Access main interface

In boot-up state, press POWER button on the panel to switch to main interface, as shown
in belowpicture:

Touch the function icons so as to access the
corresponding function operations.

USB/SD Card function operation

When there is a USB device/SD card connected,
the unit can conduct the playback of audio/video/
image files in the USB device/SD card.

Insert/Eject USB storage device

1. Connect a USB recorded with media information to the unit by a USB connecting cable.

2. When there is a need to eject the USB device, exit the USB device playback screen
first, and then take out the device.

Insert/eject SD card

1. Insert a SD card recorded with media information into the SD card slot in the unit
correctly until it is locked.

2. When pulling out the SD card, exit SD card playing state first, then press the SD card
and it shall pop up after unlocking.

Enter/exit

Insert a USB storage device or SD card to automatically play data contained in it. If the
unit has connected with a USB device or SD card, touch[ USB ]icon in the main interface
to enter into the external storage playback interface; Touch[ SD ]icon to enter into the SD
card playback interface. During playback, touch the top center area of the screen to pop
up the touch menu, operate touch menu to perform various playback controls.

Play

After SD card/USB removable device being read out, the operation methods are similar
to disk operation methods.

10

07

INSTRUCTIONS INSTRUCTIONS

Radio Function Operation

Enter/exit

Touch [ RADIO ] icon in the main interface to enter into the radio interface.
Touch icon to return to main interface, and then touch other function icons so as to exit

radio mode.

Band selection

Click [BND] icon so as to switch among AM1, AM2, Fm1,FM2, FM3 bands.

Search/Save radio stations

Short press [Scan] icon to browse the stored radio stations.
FM band can save 18 radio stations (Six stations for FM1/FM2/FM3), AM band can save

12 radio stations (Six stations for AM1/AM2).

Scan radio

Short press icon to manually fine-tune radio stations upward/downward.
Long press icon to automatically search and save radio stations.

Sound setting

Click [Sound] icon can switch to different sound mode.

Turn on/off the Long/Short-range

Click [Long/Short-range] icon so as to turn on/off Long/Short-Range function.
Note: This function is available only when FM band is selected.

Loudness on/off

Click [Loudness] icon so as to turn on/off loudness function.

Stereo on/off

When receiving stereo signals, click [Stereo] icon to turn on/off stereo.

Mute on/off

Click [Mute] icon to turn on/off mute function

TFT on/off

Click icon to turn off TFT, and then click the screen area so as to turn on TFT.
Click icon so as to slide screen angle.

Disc Function Operation

Play/eject disc

Play disc

Insert the disc into the disc slot with the printing surface up, system will detect the disc
and automatically take it in to read and play.

Eject disc

(1) Click button on the panel to eject the disc.
(2) If a disc has not been took away 15 seconds after it is ejected, system will
automatically take in the disc but not play.

Do not insert two discs or more.

DVD/VCD disc playback

During playback of disc, touch the middle lower area of the screen to pop up the touch
menu, operate the touch menu to perform various playback controls.(PIC 1)

CD Disc Playback

After a CD is inserted, system shall access reading state immediately.disc
When there is a in the device, click [ ] at the main interface so as to access

disc Disc disc

reading state.
After the being read out, system shall automatically play in sequence.disc

MP3/JPEG/MPEG4 disk playing

When the contains readable files, such as MP3/JPEG/MPEG4 files, it shall be

disc

automatically read out and played after slipping into DVD player.
During playing, touch the screen area and the touch menu shall pop up. Operate the
touch menu for various playing.

Touch Menu Function Description

Play/pause

Touch the button to pause, retouch it to continue to play.

Stop

Touch the button to enter into prestop status.

Fast forward/backward

Consecutively touch this button to select the speed of fast-forward/fast-backward.

The previous/next song

Touch the button to select the previous/next song.

Volume adjustment button
Touch this button and volume adjustment modulation shall pop up, touch button to
adjust the volume.

TT 1/5 CH 1/1

x

００

TT 1/5 CH 1/1

x

００

００:０１:４４ ００:０９:４３

VOL

００:０１:４４ ００:０９:４３

VOL

PIC 1

08

09