Bosch RE005EV2 User Manual

Note: The button functions are fixed and cannot be changed as per the
diagram below.

Panic Function: The fob can generate a panic on the Solution panel. Holding

down buttons 1 and 2 for a period of 2 seconds will cause a panic alarm.

AWAY Arm/Disarm STAY Arm/Disarm
Output 1 Relay Output 2 Relay

Specifications
Receiver

Operating Voltage 9 - 15VDC
Current Consumption 9mA Standby
43mA Both relays operating
Relay Rating SPDT 1Amp Maximum carry @ 12VDC
Reverse Polarity protection Yes. Diode
Operating Frequency 433.92mhz
Receiver Type Superheterodyne AM ASK
Bandwidth 250khz
Antenna 165mm solid core insulated wire
Fob Storage EEPROM Maximum 21 Fobs

Transmitter (Fob)

Operating Voltage 3V Lithium Battery CR2032
Operating Frequency 433.92mhz
Bandwidth 260khz
Tuning SAW resonator locked
Channels 4
Weight 33g including battery
Visual Indicator Blue LED

RE005EV2

RF Arming Kit for SolutionTM 16

N2127

Overview
The RE005EV2 RF Arming Kit is designed to provide a convenient ON/OFF

Control for the Solution16 alarm panels. Provision is also made for the control of
up to two (2) external devices via on board relays.

Features

* Code Hopping RF security ( 4.2 billion combinations )
* Simple installation
* Superheterodyne receiver (less interference)
* Robust attractive keyfobs
* Two onboard programmable relays

+ - CLK

Connect to +12
Connect to GND
Connect to CLK

Connection for antenna.
17cm wire or coax to external 434mhz
antenna. Coax shield connects to GND

Learn/Delete
Switch

SPDT relays x 2

Microprocessor

Led

Connection to relays.
1 Amp maximum @
12VDC

RE005EV2

Installation and Set up

1. Select a location to install the ABS bulkhead case of the receiver which
is non metallic. Metal objects close to the receiver may affect range.

2. Connect wiring to Solution 16 keypad bus.

3. In the installer programming of the Solution 16 set;
Location 666 = Option 1 enabled Location 665 = Option 8 enabled

if horn speaker beeps are required.

4. The supplied fobs are already learned to the RE005EV2 with both relays
set for momentary operation. If however a different relay set up is required
then the fobs will need to be deleted and learned again as below.

TO DELETE FO BS - Press and hold the Learn/Delete switch. Note that
the LED will light and then extinguish after 4 seconds. The EEPROM
memory is now erased. Individual fob deletion is not possible.

TO LEARN FOBS - Press the Learn/Delete switch once. Note that the
LED will flash rapidly. Now press the button on the FIRST fob to be
learned corresponding to the relay functions required ( see below). The
LED will come on solid whilst receiving the transmission and then flash
once to confirm learning. Repeat for additional fobs ( maximum 21). It is
not important which button is pressed on fobs learned after the FIRST as
the relay functions are set by the FIRST learned fob.

Relay Programming
Button 1 = Both outputs momentary

Button 2 = Output 1 toggling, Output 2 momentary
Button 3 = Output 2 toggling, Output 1 momentary
Button 4 = Both outputs toggling

5. Press the Learn/Delete button once when finished learning fobs. Note that
if no RF activity occurs the RE005EV2 will leave learn mode automatically
after 20 seconds.

6. Test Operation.