Read these instructions carefully. Please keep
the instruction and installation manual, as well
as the appliance certificate, in a safe place for
later use or for subsequent owners.
Check the appliance for damage after
unpacking it. Do not connect the appliance if it
has been damaged in transport.
Only a licensed professional may connect
appliances without plugs. Damage caused by
incorrect connection is not covered under
warranty.
This appliance is intended for private domestic
use and the household environment only. The
appliance must only be used for the
preparation of food and beverages. The
cooking process must be supervised. A short
cooking process must be supervised without
interruption. Only use the appliance in
enclosed spaces.
This appliance is intended for use up to a
maximum height of 2000 metres above sea
level.
This appliance may be used by children over
the age of 8 years old and by persons with
reduced physical, sensory or mental
capabilities or by persons with a lack of
experience or knowledge if they are
supervised or are instructed by a person
responsible for their safety how to use the
appliance safely and have understood the
associated hazards.
Children must not play with, on, or around the
appliance. Children must not clean the
appliance or carry out general maintenance
unless they are at least 15 years old and are
being supervised.
Keep children below the age of 8 years old at
a safe distance from the appliance and power
cable.
(Important safety
information
Impor t ant safety informati on
:Warning – Risk of fire!
■ Hot oil and fat can ignite very quickly. Never
leave hot fat or oil unattended. Never use
water to put out burning oil or fat. Switch off
the hotplate. Extinguish flames carefully
using a lid, fire blanket or something similar.
Risk of fire!
■ The hotplates become very hot. Never
place combustible items on the hob. Never
place objects on the hob.
Risk of fire!
■ The appliance gets hot. Do not keep
combustible objects or aerosol cans in
drawers directly underneath the hob.
Risk of fire!
■ The hob switches off automatically and can
no longer be operated. It may switch on
unintentionally at a later point. Switch off the
circuit breaker in the fuse box. Contact the
after-sales service.
Risk of burns!
■ Do not use hob covers here.They can
cause accidents, for example due to
overheating, catching fire or materials
shattering.
:Warning – Risk of burns!
■ The hotplates and surrounding area
(particularly the hob surround, if fitted)
become very hot. Never touch the hot
surfaces. Keep children at a safe distance.
Risk of burns!
■ The hotplate heats up but the display does
not work. Switch off the circuit breaker in
the fuse box. Contact the after-sales
service.
Risk of burns!
■ It is only allowed to use safety devices, e.g.
child protection grilles, which have been
approved by ourselves. Unsuitable safety
devices or child protection grilles may result
in accidents.
:Warning – Risk of electric shock!
■ Incorrect repairs are dangerous. Repairs
may only be carried out and damaged
power cables replaced by one of our
trained after-sales technicians. If the
appliance is defective, unplug the appliance
from the mains or switch off the circuit
breaker in the fuse box. Contact the aftersales service.
Risk of electric shock!
■ Do not use any high-pressure cleaners or
steam cleaners, which can result in an
electric shock.
Risk of electric shock!
■ A defective appliance may cause electric
shock. Never switch on a defective
appliance. Unplug the appliance from the
mains or switch off the circuit breaker in the
fuse box. Contact the after-sales service.
Risk of electric shock!
■ Cracks or fractures in the glass ceramic
may cause electric shocks. Switch off the
circuit breaker in the fuse box. Contact the
after-sales service.
3
en Causes of damage
:Warning – Risk of injury!
Saucepans may suddenly jump due to liquid
between the pan base and the hotplate.
Always keep the hotplate and saucepan bases
dry.
]Causes of damage
Cau s e s of damage
Caution!
■ Rough pot and pan bases scratch the ceramic.
■ Avoid boiling pots dry. This may cause damage.
■ Never place hot pots or pans on the control panel,
the display area or the surround. This may cause
damage.
■ Damage can occur if hard or pointed objects fall on
the hob.
■ Aluminium foil and plastic containers melt on hot
hotplates. Oven protective foil is not suitable for your
hob.
Overview
You will find the most frequently caused damage in the
following table.
DamageCauseMeasure
StainsBoiled over foodRemove boiled over food imme-
diately with a glass scraper.
Unsuitable cleaning agents
ScratchesSalt, sugar and
sand
Rough pot and
pan bases
scratch the
ceramic.
DiscolourationUnsuitable clean-
ing agents
Pan abrasion (e.g.
aluminium)
BlistersSugar, food with a
high sugar content
Only use cleaning agents that
are suitable for glass ceramic.
Do not use the hob as a work
surface or storage space.
Check your cookware.
Only use cleaning agents that
are suitable for glass ceramic.
Lift pots and pans when moving
them.
Remove boiled over food immediately with a glass scraper.
7Environmental protection
Env i r on ment al prot ect i on
In this section, you can find information about saving
energy and disposing of the appliance.
Energy-saving tips
■ Always place suitable lids on saucepans. When
cooking without a lid, considerably more energy is
required. A glass lid means that you can see inside
without having to lift the lid.
■ Use pots and pans with even bases. Uneven bases
increase energy consumption.
■ The diameter of pot and pan bases should be the
same size as the hotplate. In particular, small
saucepans on the hotplate cause energy losses.
Please note: cookware manufacturers often indicate
the upper diameter of the saucepan. This is usually
bigger than the diameter of the base of the pan.
■ Use a small saucepan for small quantities. A larger,
less full saucepan requires a lot of energy.
■ Cook with only a little water. This will save energy.
Vitamins and minerals in vegetables are preserved.
■ Always cover as large an area of the hotplate as
possible with your saucepan.
■ Switch to a lower heat setting in good time.
■ Select a suitable ongoing cooking setting. You will
waste energy by using an ongoing cooking setting
which is too high.
■ Use the residual heat of the hob. For longer cooking
times, you can switch the hotplate off 5-10 minutes
before the end of the cooking time.
Environmentally-friendly disposal
Dispose of packaging in an environmentally-friendly
manner.
This appliance is labelled in accordance with
European Directive 2012/19/EU concerning
used electrical and electronic appliances
(waste electrical and electronic equipment WEEE). The guideline determines the
framework for the return and recycling of used
appliances as applicable throughout the EU.
4
*Getting to know your
[
W\
|
appliance
Gett i ng to know your appl i ance
The instruction manual is the same for various different
hobs. You can find the hob dimensions in the overview
of models. ~ Page 2
Controls without illuminated bars above the symbols
ä
Notes
■ Depending on the operating condition of the hob the
controls which can currently be selected light up
brightly or dimmed. If you touch them, the relevant
function is activated.
■ The controls which cannot currently be selected do
not light up.
■ Always keep the controls dry. Moisture reduces their
effectiveness.
Heat settings
Residual heat
Keep warm function
Timer
Main switch
Childproof lock
Wipe protection
Keep warm function
Settings range
Sensor frying system
Automatic zone control
Kitchen timer
Timer
Stopwatch function
Hotplate selection
■ Do not pull pans close to the displays and sensors.
The electronics could overheat.
The hotplates
HotplateActivating and deactivating
Single-circuit hot-
$
plate
Dual-circuit hotplate
ð
Tri-circuit hotplate
ò
When the hotplate is activated: the corresponding indicator lights up
Notes
■ Any dark areas in the glow pattern of the hotplate
are due to technical reasons. The function of the
hotplate is not affected.
■ Hotplate temperature is regulated by the heat
switching on and off.The heat may also switch on
and off at the highest setting.
This ensures e.g.:
– sensitive components are protected from
overheating
– the appliance is protected from electrical
overload
– better cooking results are achieved
■ With multi-circuit hotplates the heater elements of the
inner filament circuits and the heater element of the
activations may switch on and off at different times.
Touch the ö symbol
Touch the ösymbol; the 2nd filament
circuit is activated
Touch the ö symbol again; the 3rd fila-
ment circuit is activated
5
en Operating the appliance
â Hotplates with bridge heating element
Two individual hotplates can be interconnected with a
bridge heating element to create one large extended
cooking zone.
Under normal operation these hotplates both work as
normal single-circuit and dual-circuit hotplates.
To activate the bridge heating element: the single-circuit
hotplate must be switched off.
1. Switch on the dual-circuit hotplate.
2. Touch the ö symbol. The outer filament circuit on
the dual-circuit hotplate is activated. The display
lights up.
3. Touch the ö symbol again. The extended cooking
zone is activated. The display lights up.
To deactivate the extended cooking zone: touch the ö
symbol again. The display goes out. The extended
cooking zone is deactivated.
Note: If you activate the extended cooking zone, the
outer filament circuit of the dual-circuit hotplate is
automatically deactivated.
Residual heat indicator
The hob has a two-stage residual heat indicator for
each hotplate.
If • appears in the display the hob is still hot. It may be
used, for example, to keep a small meal warm or to
melt cooking chocolate. As the hotplate cools down
further, the display changes to œ. The display remains lit
until the hotplate has cooled sufficiently.
■ The settings remain stored for 4 seconds after the
hob has been switched off.If you switch it on again
during this time, the hob will operate using the
previously stored settings.
Setting a hotplate
Select the desired heat setting on the control panel.
Heat setting 1 = Lowest power
Heat setting 9 = Highest power
Every heat setting has an intermediate setting. It
appears on the display, e.g. as ….†.
Set the heat setting
The hob must be switched on.
1. Touch the ø symbol to select the hotplate.
‹‹ lights up brightly on the heat setting display.
2. Set the required heat setting in the control panel.
1
The hotplate is switched on.
Changing the heat setting:
Select the hotplate and set the required heat setting in
the control panel.
2
1Operating the appliance
Operat i ng the appl i ance
In this section, you can find out how to set the
hotplates. The table shows heat settings and cooking
times for various meals.
Switching the hob on and off
The main switch is used to switch the hob on and off.
Switching on
Touch the # symbol. An audible signal sounds. The
illuminated bar above the main switch lights up. The
displays for the controls and the heat settings ‹ light
up. The hob is ready to use.
Switching off
Touch the # symbol until the illuminated bar above the
main switch and the displays go out.All hotplates are
switched off. The residual heat indicator remains on
until the hotplates have cooled down sufficiently.
Notes
■ The hob will switch itself off automatically once all
hotplates have been switched off for a while (1060 seconds).
Switching off the hotplate
Select the hotplate. Set the control panel to 0. After
about 10 seconds, the residual heat indicator appears.
Note: The last selected hotplate remains activated. You
can set the hotplate without selecting it again.
Table of cooking times
The following table provides some examples.
Cooking times and heat settings may vary depending
on the type of food, its weight and quality. Deviations
are therefore possible.
For bringing liquids to the boil, use heat setting 9.
Stir thick liquids occasionally.
Food that needs to be seared quickly or food which
loses a lot of liquid during initial frying is best seared in
several small portions.
Tips for energy-saving cooking can be found in the
Environmental protection section.~ Page 4
6
Loading...
+ 14 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.