Bosch MUM57860AU User Manual
MUZ5FW1
For your safety
en
The accessories are suitable for the food processor MUM5... .
Follow the operating instructions for the food processor MUM5… .
This appliance is suitable for mincing and mixing raw or cooked meat,
bacon, poultry and fish. It must not be used for processing other objects or
substances.
Other applications are possible if the accessories approved by the
manufacturer are used.
, Safety instructions for this appliance
Risk of injury!
Do not reach into the feed tube, always use the pusher to add more
ingredients.
Do not attach/remove the mincer until the drive is at a standstill.
Important!
Use the mincer in the specified operating position only.
The mincer must be completely assembled before use. Never assemble
the mincer attachment on the base unit.
Overview
Please fold out the illustrated pages.
Fig.
1 Mincer attachment
a Threaded ring
b Perforated disc (hole diameter 4.5 mm)
c Blade
d Worm gear with driver
e Locking lever
f Seal
2 Filler tray
3 Pusher
Optional accessories
4 Fruit press attachment
5 Viennese whirl attachment
6 Grater attachment
7Perforated disc
(hole diameter 3 mm and 6 mm)
Fig.
Operating position
Protection from overload
To prevent serious damage to your appliance
if the mincer is overloaded, the driver has
a notch (predetermined breaking point).
If an overload occurs, the driver breaks instead.
However, the driver can easily be replaced.
A new driver is available from customer service.
Unscrew fastening screw on the worm gear.
Replace driver.
Tighten fastening screw.
Operating the appliance
Thoroughly clean the mincer before using for
the first time, see “Cleaning and care”.
Important information
In these instructions for use the recommended
reference values for the operating speed refer to
appliances with a 7-setting rotary switch.
For appliances with a 4-setting rotary switch
you can find the values in brackets after
the values for a 7-setting rotary switch.
Assemble mincer attachment in the
indicated sequence (Fig. ). Do not fully
tighten threaded ring.
Insert seal. Note position (Fig. )!
Fig.
Press the Release button and move
the swivel arm to position 4.
Connect mincer to the drive.
Note position of the driver with respect
to the drive. If required, turn the driver
slightly.
To do this, the threaded ring must not
be screwed tightly!
2 Robert Bosch Hausgeräte GmbH
Turn mincer anti-clockwise.
en
Subject to alterations.
Press down locking lever.
Now tighten the threaded ring.
Attach filler tray.
Place a bowl or plate under the outlet
opening.
Insert the mains plug.
Set rotary knob to setting 7 (4).
Place the food to be processed in the filling
tray.
Use the pusher to push in ingredients.
t~кебеЦ>
aз=езн=йкзЕЙлл=ДзеЙлK
Tip: Process steak tartare through the mincer
twice.
After using the appliance
Switch off the appliance with the rotary
switch.
Lift up locking lever.
Rotate the mincer in a clockwise direction
and remove.
Clean mincer.
Cleaning and servicing
^ннЙенбзе>
aз=klq=млЙ=~Дк~лбоЙ=ЕдЙ~ебеЦ=~ЦЙенлK=
pмкС~ЕЙл г~у=ДЙ=З~г~ЦЙЗK
jбеЕЙк=~еЗ=беЗбобЗм~д=й~кнл=~кЙ=езн=
ЗблЬп~лЬЙкJйкззСK
Loosen threaded ring and disassemble
attachment.
Rinse individual parts by hand and dry
immediately.
Optional accessories
(available from dealers)
t~кебеЦ>
^дп~ул=~ллЙгДдЙ=нЬЙ=~ЕЕЙллзкбЙл=пбнЬзмн=
Дд~ЗЙл=~еЗ=йЙкСзк~нЙЗ=ЗблЕлK=
cзддзп=~дд=белнкмЕнбзел=гЙенбзеЙЗ=~ДзоЙ=
ЕзеЕЙкебеЦ=“cзк=узмк=л~СЙну ТI=“^СнЙк=пзквТ=
зк “`дЙ~ебеЦ=~еЗ=лЙкобЕбеЦТK
Fruit press attachment
for pressing e.g. berries, tomatoes, apples,
pears, rosehips (cook rosehips for 1 hour before
pressing). Extracted fruit pulp is especially
suitable for making jam.
Fig.
Preparation as described for mincer
attachment. Note required individual parts
and sequence when assembling the fruit
press attachment.
First undo the fastening screw as far as is
required to allow the pulp to flow out while
still moist.
Then adjust the fastening screw until the
pulp flows out with the required moisture.
Place the food to be processed in the filling
tray.
Use the pusher to push in ingredients.
Set rotary knob to setting 7 (4).
Viennese whirl attachment
for shaping biscuit dough or short pastry.
Fig.
Preparation as described for mincer
attachment. Note required individual parts
and sequence when assembling the biscuit
attachment.
Place the dough to be processed in the
filling tray. Use the pusher to push in
ingredients.
Turn rotary switch to setting 4 (2) or 5 (3)
depending on dough consistency.
Separate the shaped dough coming out
of the appliance with a pastry cutter.
Briefly switch off the food processor
if the dough comes out too quickly.
Grater attachment
for grating almonds, nuts and dried bread
or bread rolls.
t~кебеЦ>
mкзЕЙлл=зеду=Зку=емнл=~еЗ=~дгзеЗл=бе=лг~дд=
им~енбнбЙл>
Fig.
Preparation as described for mincer
attachment. Note required individual parts
and sequence when assembling the grating
attachment.
Place the food to be processed in the filling
tray.
Use the pusher to push in ingredients.
Turn rotary switch to setting 3 (2) or 4 (3)
depending on hardness of the food.
Robert Bosch Hausgeräte GmbH 3
Loading...