Page 1
Wireless Temperature Sensor (TS-S1)
PPaarrttss DDeessccrriippttiioonn
1. Temperature Sensor
2. Internal LED
The LED Indicator will light up when any button is pressed.
3. Learn Button
Press to transmit learn code and temperature information.
4. Battery Compartment
PPaacckkaaggee CCoonntteenntt
1 x Temperature Sensor
2 x wall plugs and screws
1 x adhesive pads
1 x 3.6V 1/2AA lithium batteries
Put the Control Panel into learning mode, then press the learn
button to transmit learn code. Please refer to Control Panel manual
to complete the learning process.
The Temperature Sensor has 2 knockouts on the inside of back
cover where plastic is thinner for wall mounting. Alternatively, you
can also use the double side adhesive tape provided to glue the
Temperature Sensor to the mounting location.
1. Use the two knockouts on the back to mark position on the
wall.
2. Drill holes into the wall using the knockouts as template.
3. Fix the Temperature Sensor base onto the wall with the screw
and plugs provided.
4. Replace the front cover onto the base.
TTeemmppeerraattuurree DDeetteeccttiioonn
The Temperature Sensor will transmit temperature information to
the Control Panel every 30 minutes, or when the learn button is
pressed.
The temperature detection range of the Temperature Sensor is
-10℃ ~ 50℃
BBaatttteerryy
The Temperature Sensor uses one 3.6V 1/2AA lithium battery as
its power source. It also features low battery detection function to
notify the Control Panel when battery voltage is low.
When the Temperature Sensor is on low battery, follow the
procedure below to change the batteries.
1. Open the back cover.
2. Remove the old battery.
3. Insert the new batteries observing correct polarity.
4. Replace the back cover.
EEnnvviirroonnmmeennttaall CCoonnddiittiioonn
-10°C to 50°C, relative humidity 85% non-condensing.
RRaaddiioo
868 MHz
LLeeaarrnniinng
g
OOppeerraattiioon
n
SSppeecciiffiiccaattiioon
n
IInnssttaallllaattiioon
n
Surface Fixing
Knockouts x 2
(Inside)
Page 2
Loading...